| *A | w/ Secondary Air Injection System | - | - |
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during ignition coil assembly or spark plug removal/installation are shown below.
25760 1.DISCONNECT VACUUM TRANSMITTING HOSE ASSEMBLY
12262 2.DISCONNECT NO. 2 VENTILATION HOSE
17735 3.REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE
25701B 4.REMOVE NO. 1 EMISSION CONTROL VALVE SET (w/ Secondary Air Injection System)
25702B 5.REMOVE NO. 2 EMISSION CONTROL VALVE SET (w/ Secondary Air Injection System)
82121 6.SEPARATE ENGINE WIRE
17126 7.REMOVE NO. 2 SURGE TANK STAY
23801P 8.SEPARATE NO. 1 FUEL PIPE SUB-ASSEMBLY AND NO. 2 FUEL PIPE
19500 9.REMOVE IGNITION COIL ASSEMBLY
| *A | Bank 1 | *B | Bank 2 |
Disconnect the 6 ignition coil assembly connectors.
Remove the 6 bolts and 6 ignition coil assemblies from the cylinder head cover sub-assembly.
If an ignition coil assembly has been struck or dropped, replace it.