Home › Drivetrain › JF2BM (TRANSFER / 4WD / AWD) › TRANSFER SYSTEM
RM38G0E _52 Drivetrain _100437 JF2BM TRANSFER / 4WD / AWD _0467431 TRANSFER SYSTEM C

JF2BM TRANSFER / 4WD / AWD  TRANSFER SYSTEM  P17CA9E  4WD/AWD Rear Differential Lock Switch "A" Stuck On  P17CA9F  4WD/AWD Rear Differential Lock Switch "A" Stuck Off  


DESCRIPTION

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from
P17CA9E 4WD/AWD Rear Differential Lock Switch "A" Stuck On
Diagnosis Condition:
·

With ignition switch turned to ON


Malfunction Status:
·

With vehicle speed higher than 0 km/h (0 mph), differential of rear wheel speed 1 km/h (0.6 mph) or higher, rear differential lock position switch (differential lock indicator switch) is stuck ON


Malfunction Time:
·

2 seconds or more


Number of Trips:
·

1 trip


·

Wire harness and connector

·

Rear differential lock position switch (differential lock indicator switch)

·

4 wheel drive control ECU


Four Wheel Drive
P17CA9F 4WD/AWD Rear Differential Lock Switch "A" Stuck Off
Diagnosis Condition:
·

With ignition switch turned to ON, rear differential locked (rear differential lock solenoid (electronic differential lock case sub-assembly) operating)


Malfunction Status:
·

With vehicle speed 5 km/h (3.1 mph) or higher, differential of rear wheel speed 3 km/h (1.8 mph) or lower, rear differential lock position switch (differential lock indicator switch) is stuck OFF


Malfunction Time:
·

120 seconds or more


Number of Trips:
·

1 trip


·

Wire harness and connector

·

Rear differential lock position switch (differential lock indicator switch)

·

4 wheel drive control ECU


Four Wheel Drive

WIRING DIAGRAM

C460068E01
5.094,2.708 6.833,2.896 1.74,0.188 10 false 4 Wheel Drive Control ECU 5.073,2.531 5.531,2.729 0.458,0.198 10 false B8 5.26,1.865 5.719,2.063 0.458,0.198 10 false SLS 4.979,1.885 5.292,2.083 0.313,0.198 10 false 18 2.479,1.885 3.094,2.083 0.615,0.198 10 false RLY2 1.365,1.885 1.823,2.083 0.458,0.198 10 false GND 1.146,1.885 1.302,2.083 0.156,0.198 10 false 1 2.948,1.865 3.104,2.063 0.156,0.198 10 false 2 0.958,2.552 3.365,3.229 2.406,0.677 10 false Rear Differential Lock Position Switch (Differential Lock Indicator Switch) 0.958,2.375 1.26,2.604 0.302,0.229 10 false V12 6.094,1.427 6.406,1.625 0.313,0.198 10 false IG

PROCEDURE

1.CHECK HARNESS AND CONNECTOR (4 WHEEL DRIVE CONTROL ECU - REAR DIFFERENTIAL LOCK POSITION SWITCH (DIFFERENTIAL LOCK INDICATOR SWITCH))
a.

Disconnect the B8 4 wheel drive control ECU connector.


b.

Disconnect the V12 rear differential lock position switch (differential lock indicator switch) connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition

Click Location & Routing(B8,V12)Location & Routing

Click Connector(B8)Instrument Panel>Engine Room Main Wire / Heater Blower Wire>4 Wheel Drive Control ECU

Click Connector(V12)Body>Differential Wire / Frame Wire>Differential Position Switch (Rear Differential Assembly)

B8-18 (SLS) - V12-2 (RLY2) Always Below 1 Ω
B8-18 (SLS) or V12-2 (RLY2) - Body ground Always 10 kΩ or higher
V12-1 (GND) - Body ground Always Below 1 Ω



d.

Connect the V12 rear differential lock position switch (differential lock indicator switch) connector.


e.

Connect the B8 4 wheel drive control ECU connector.


Result:
Proceed to
OK
NG



OK

2.INSPECT REAR DIFFERENTIAL LOCK POSITION SWITCH (DIFFERENTIAL LOCK INDICATOR SWITCH)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.INSPECT REAR DIFFERENTIAL LOCK POSITION SWITCH (DIFFERENTIAL LOCK INDICATOR SWITCH)
a.

Inspect the rear differential lock position switch (differential lock indicator switch).

Click hereDrivetrain>AXLE AND DIFFERENTIAL>REAR DIFFERENTIAL LOCK POSITION SWITCH>INSPECTION


Result:
Proceed to
OK
NG



OK

NG

REPLACE DIFFERENTIAL LOCK INDICATOR SWITCH