Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM
RM38G0E _58 Vehicle Interior _100611 METER / GAUGE / DISPLAY _0467504 METER / GAUGE SYSTEM J

METER / GAUGE / DISPLAY  METER / GAUGE SYSTEM  Odo/Trip Switch Malfunction  


DESCRIPTION

The ODO/TRIP display of the combination meter changes each time the trip switch is pressed.

WIRING DIAGRAM

B608404E01
4.438,3.135 6.302,3.354 1.865,0.219 10 false Combination Meter Assembly 4.448,2.969 4.906,3.167 0.458,0.198 10 false I5 5.615,1.531 6.073,1.729 0.458,0.198 10 false I/F 2.771,0.833 3.229,1.031 0.458,0.198 10 false + 2.76,2.021 2.958,2.219 0.198,0.198 10 false E 3.042,0.844 3.198,1.042 0.156,0.198 10 false 5 4.385,0.844 4.604,1.073 0.219,0.229 10 false 20 3.042,2.021 3.198,2.219 0.156,0.198 10 false 4 4.688,0.844 5.146,1.042 0.458,0.198 10 false ODO 1.865,2.521 2.323,2.719 0.458,0.198 10 false I80 1.885,2.698 2.625,2.948 0.74,0.25 10 false Trip Switch 1.906,1.156 2.625,1.344 0.719,0.188 10 false ODO TRIP

CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.

·

When the combination meter assembly is replaced, update the ECU security key.

Click hereGeneral>SETUP>WHEN REPLACING OR REMOVING/INSTALLING PARTS>UPDATE ECU SECURITY KEY



PROCEDURE

1.READ VALUE USING GTS (ODO/TRIP CHANGE SWITCH)
a.

Using the GTS, read the Data List.

Click hereVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>DATA LIST / ACTIVE TEST

Body Electrical > Combination Meter > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
ODO/TRIP Change Switch ODO/TRIP switch (Trip switch) OFF or ON OFF: ODO/TRIP switch (trip switch) released
ON: ODO/TRIP switch (trip switch) pushed
-
Body Electrical > Combination Meter > Data List
Tester Display
ODO/TRIP Change Switch
50003 409 2
OK:

ODO/TRIP switch condition displayed on the GTS changes with the actual switch operation.



Result:
Proceed to
OK
NG



OK

REPLACE COMBINATION METER ASSEMBLY

NG

2.INSPECT TRIP SWITCH
2.INSPECT TRIP SWITCH

OK

3.CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - TRIP SWITCH)

NG

3.CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - TRIP SWITCH)
a.

Disconnect the I5 combination meter assembly connector.


b.

Disconnect the I80 trip switch connector.



Result:
Proceed to
OK
NG



OK

REPLACE COMBINATION METER ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR