Use the same procedure for the LHD and RHD vehicles.
The procedure listed below is for the LHD vehicles.
45130 1.INSTALL HORN BUTTON ASSEMBLY
| *a | Turns off | - | - |
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
Wait at least 60 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.
Engage the clamp.
When replacing the spiral cable sub-assembly with a new part, perform the following procedure.
1. Remove the airbag connector from the clamp.
Connect the horn connector.
Connect the airbag connector.
When connecting any airbag connector, take care not to damage the airbag wire harness.
Make sure the lock button is securely locked.
Refer to How to Connect or Disconnect Airbag Connector: Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>HOW TO CONNECT OR DISCONNECT AIRBAG CONNECTOR
Set the horn button assembly to the steering wheel assembly.
Check that the airbag wire harness and horn wire harness are not pinched.
Press the horn button assembly with both hands to engage the upper pin to the upper spring.
Press the horn button assembly with both hands to engage the lower pin to the lower spring to install the horn button assembly.
After installation, try to pull the horn button assembly and check that the horn button assembly is securely installed.
2.INSTALL LOWER NO. 2 STEERING WHEEL COVER
3.INSTALL LOWER NO. 3 STEERING WHEEL COVER
4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
for 1GR-FE:
for V35A-FTS:
5.INSPECT HORN BUTTON ASSEMBLY
6. PERFORM DIAGNOSTIC SYSTEM CHECK
7.CHECK SRS WARNING LIGHT
8. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE
When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART