Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › REAR SEAT SIDE AIRBAG ASSEMBLY (for LH Side) › 2021.04–2021.07
RM38G0E _58 Vehicle Interior _100751 SUPPLEMENTAL RESTRAINT SYSTEMS _0467883 REAR SEAT SIDE AIRBAG ASSEMBLY(for LH Side) A

SUPPLEMENTAL RESTRAINT SYSTEMS  REAR SEAT SIDE AIRBAG ASSEMBLY(for LH Side)  REMOVAL  


CAUTION / NOTICE / HINT

COMPONENTS (REMOVAL)
B612023N01
1.917,0.083 3.5,0.5 1.583,0.417 6.531,0.625 6.781,0.625 true 2.823,0.271 3.073,0.271 true 6.594,0.208 6.844,0.208 true 3.427,0.771 3.677,0.771 true 4.427,1.979 4.677,1.979 true 4.906,3.021 4.906,3.271 true 6.229,3.51 5.958,3.51 true 4.396,1.24 4.396,1.49 true 4.26,0.917 4.51,0.917 true 6.469,0.052 6.76,0.448 0.292,0.396 18 false 1 6.385,0.458 6.667,0.813 0.281,0.354 18 false 2 3.104,0.115 3.385,0.469 0.281,0.354 18 false 3 3.708,0.615 3.99,0.969 0.281,0.354 18 false 4 4.833,3.229 5.115,3.583 0.281,0.354 18 false 6 6.479,3.354 6.76,3.708 0.281,0.354 18 false 7 1.854,1.125 2.313,1.323 0.458,0.198 10 false x 2 4.281,2.052 4.74,2.25 0.458,0.198 10 false x 2 4.698,1.875 5.156,2.073 0.458,0.198 10 false ● 1.979,0.115 2.354,0.354 0.375,0.24 12 false *A 4.323,1.458 4.604,1.813 0.281,0.354 18 false 5 4.042,0.823 4.5,1.021 0.458,0.198 10 false ●*1 4.219,1.521 4.677,1.719 0.458,0.198 10 false ●

Procedure Part Name Code
Z101186

Z101188

Z101187

1 PRECAUTION - (Click here) - -
2 DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL - (Click here) - -
3 REAR SEATBACK COVER 72996H - - -
4 REAR SEATBACK BOARD SUB-ASSEMBLY LH 71702D - - -
5 REAR SEAT COVER HANGER 71751D - - -
6 REAR SEATBACK FRAME LH 71252 (Click here) - -
7 REAR SEAT AIRBAG ASSEMBLY LH 73940A (Click here) - -

*A w/ Child Restraint System Guide - -
*1 RIVET - -
● Non-reusable part - -

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the rear seat airbag assembly LH removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedures Effect/Inoperative Function When Necessary Procedures are not Performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point Parking assist monitor system (Click here)
Multi-terrain monitor system (Click here)
Panoramic view monitor system (Click here)

HINT:

When the cable is disconnected/reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Stop and start system Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) (Click here)
Lighting system (EXT) Cornering lights Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 seconds or more. (Click here)
Pre-collision system
Lane tracing assist system
Lane departure alert system
Adaptive high beam system

·

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power back door system Fully close the back door by hand.
HINT:

Initialization is not necessary if the above procedures are performed while the back door is closed.


(Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor and expansion valve standard position is recognized. -



PROCEDURE

Hide 1. PRECAUTION

Z101186

CAUTION:
·
B475753

Be sure to read precaution thoroughly before servicing.

Click here(Click here)

·
B543257

Wear protective gloves. Sharp areas on the parts may injure your hands.

·

There is risk of injury.



NOTICE:

After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) battery terminal.

Click here(Click here)



Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Z101186

CAUTION:
B422343

·

Wait at least 60 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

·

If the airbag deploys for any reason, it may cause a serious accident.





Hide 72996H 3.REMOVE REAR SEATBACK COVER (w/ Child Restraint System Guide)

Hide 71702D 4.REMOVE REAR SEATBACK BOARD SUB-ASSEMBLY LH

a.
B609779C01
5.156,2.792 5.385,2.979 0.229,0.188 12 true *A
*A w/ Child Restraint System Guide - -



Hide 71751D 5.REMOVE REAR SEAT COVER HANGER

a.
B609782C01
5.219,0.99 5.552,0.656 true 5.51,0.396 5.76,0.167 true 2.729,1.042 2.906,1.25 0.177,0.208 10 false A 0.969,0.115 1.146,0.323 0.177,0.208 10 false A 4.375,0.052 4.771,0.323 0.396,0.271 10 false A - A 5.76,0.052 6.156,0.323 0.396,0.271 10 false *a 5.073,0.917 5.469,1.188 0.396,0.271 10 false *b
*a J Hook A *b J Hook B



b.
B614756C01
1.542,3.031 1.792,3.031 true 5.104,3.031 5.354,3.031 true 4.948,2.927 5.26,3.125 0.313,0.198 10 false *a 1.385,2.927 1.698,3.125 0.313,0.198 10 false *b
*a J Hook A *b J Hook B
V113147

Remove in this Direction - -



Hide 71252 6.REMOVE REAR SEATBACK FRAME LH

a.
B609786N01
3.646,1.417 3.927,1.771 0.281,0.354 18 false i 3.167,1 3.448,1.354 0.281,0.354 18 false ii 2.927,0.792 3.208,1.146 0.281,0.354 18 false ii 4.458,0.313 4.74,0.667 0.281,0.354 18 false iii

i.

Disconnect the airbag connector.

NOTICE:

When disconnecting any airbag connector, take care not to damage the airbag wire harness.


HINT:

Refer to How to Connect or Disconnect Airbag Connector: Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>HOW TO CONNECT OR DISCONNECT AIRBAG CONNECTOR



ii.

Disengage the clamp.


iii.

Remove the 2 nuts and rear seatback frame LH.



Hide 73940A 7.REMOVE REAR SEAT AIRBAG ASSEMBLY LH

Z101186

CAUTION:
·
B399378N01
1.688,1.885 1.688,1.583 false 1.635,1.896 1.948,2.094 0.313,0.198 10 false *a

When storing the rear seat airbag assembly LH, keep the airbag deployment side (*a) facing upward.

·

If the airbag deploys for any reason, it may cause a serious accident.




a.
B609787N01
2.26,0.031 2.542,0.385 0.281,0.354 18 false i

i.

Remove the 2 nuts and rear seat airbag assembly LH.

CAUTION:
·

Do not reuse the nut.

·

If the installation surface or surrounding area of the rear seat airbag assembly LH is deformed or damaged, replace the rear seatback frame LH, No. 1 seatback pad LH and No. 1 seatback cover sub-assembly LH.