| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | NO. 2 COOLER WIRING HARNESS SUB-ASSEMBLY | 88605C | - | - | - |
| 2 | EVAPORATOR SUB-ASSEMBLY (REAR) | 88501R | ( ) |
- | - |
| 3 | HEATER CLAMP | - | - | - | - |
| 4 | HEATER RADIATOR UNIT SUB-ASSEMBLY | 87107B | - | - | - |
| *1 | COOLING UNIT CASE LH | *2 | COOLING UNIT CASE RH |
| ● | Non-reusable part |
|
Compressor oil ND-OIL 8 or equivalent |
|
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
|
Compressor oil ND-OIL 8 or equivalent | - | - |
88605C 1.INSTALL NO. 2 COOLER WIRING HARNESS SUB-ASSEMBLY
88501R 2.INSTALL EVAPORATOR SUB-ASSEMBLY (REAR)
|
Install in this Direction | - | - |
Remove the vinyl tape from the air conditioning tube assembly and then apply a sufficient amount of compressor oil to 2 new O-rings and the fitting surface of the evaporator sub-assembly (rear).
ND-OIL 8 or equivalent
Install the 2 O-rings to the evaporator sub-assembly (rear).
Keep the O-rings and O-ring fitting surfaces free of foreign matter.
Install the evaporator sub-assembly (rear) as shown in the illustration.
Attach the claw and install the rear cooling unit case LH.
Install the 12 screws.
Attach the clamp.
Connect the 3 connectors.
3.INSTALL HEATER CLAMP
87107B 4.INSTALL HEATER RADIATOR UNIT SUB-ASSEMBLY
88605 6.INSTALL NO. 1 COOLER WIRING HARNESS SUB-ASSEMBLY
87103D 9.INSTALL REAR BLOWER MOTOR WITH FAN SUB-ASSEMBLY
87236C 10.INSTALL HEATER BLOWER COVER
87030 13.INSTALL AIR CONDITIONING BLOWER ASSEMBLY