If the air inlet mode cannot be changed between recirculation/fresh or exhaust gas odors can be smelled even though recirculation mode is selected, the following factors may be the cause.
| Symptom | Factor |
|---|---|
|
·
Fresh/recirculation mode does not change.
·
Fresh/recirculation mode does not change automatically.
·
Exhaust gas odor when set to recirculation. |
·
Blower servo motor malfunction
·
Damper and link operation (jamming)
·
Blower assembly malfunction
·
High engine coolant temperature (high) |
Check that the No. 1 blower damper servo sub-assembly is installed correctly.
The No. 1 blower damper servo sub-assembly is installed correctly.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Check for DTCs.
| Result | Proceed to |
|---|---|
| B143A87 and B143B7F are not output | A |
| B143A87 is output | B |
| B143B7F is output | C |
A
B
C
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Coolant Temperature | Engine coolant temperature | Min.: -40°C (-40°F) Max.: 140°C (284°F) |
75 to 100°C (167 to 212°F): After warming up | This is the engine coolant temperature.
|
| Tester Display |
|---|
| Coolant Temperature |
The value of the display does not change frequently.
| Proceed to |
|---|
| OK |
| NG |
OK
NG