| ● | Non-reusable part | - | - |
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the compressor with magnet clutch removal/installation are shown below.
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1.REMOVE RADIATOR WITH COOLER CONDENSER ASSEMBLY
2.REMOVE NO. 2 AIR TUBE ASSEMBLY
17343N 3.REMOVE NO. 3 AIR HOSE
88704 4.DISCONNECT SUCTION HOSE SUB-ASSEMBLY
Remove the nut and disconnect the suction hose sub-assembly.
Remove the O-ring from the suction hose sub-assembly.
Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.
44310 5.DISCONNECT VANE PUMP ASSEMBLY
88704 6.REMOVE SUCTION HOSE SUB-ASSEMBLY
Disconnect the connector.
Remove the bolt and suction hose sub-assembly.
Remove the O-ring from the suction hose sub-assembly.
Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.
88711 7.REMOVE NO. 1 COOLER REFRIGERANT DISCHARGE HOSE
Remove the bolt No. 1 cooler refrigerant discharge hose.
Remove the O-ring from the No. 1 cooler refrigerant discharge hose.
Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.
8.REMOVE COMPRESSOR WITH MAGNET CLUTCH
Remove the 2 bolts and 2 nuts.
Using an E8 "TORX" socket wrench, remove the 2 stud bolts and compressor with magnet clutch.