| *1 | AIR CONDITIONING PRESSURE SENSOR COVER | - | - |
| ● | Non-reusable part | - | - |
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
53292A 1.REMOVE UPPER RADIATOR SUPPORT SEAL
for Standard:
Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>FRONT BUMPER (for Standard)>REMOVAL
for Aero Type:
Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>FRONT BUMPER (for Aero Type)>REMOVAL
2.RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM
86520 3.REMOVE LOW PITCHED HORN ASSEMBLY
Click hereVehicle Exterior>HORN>HORN>REMOVAL
88719A 4.REMOVE AIR CONDITIONING PRESSURE SENSOR
Disconnect the connector.
Remove the air conditioning pressure sensor cover.
| *a | Turn | *b | Hold |
Using a 27 mm deep socket wrench, remove the air conditioning pressure sensor.
Do not apply excessive force to the air conditioning tube and accessory assembly.
Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.