| *A | for LH Side | *B | w/ Courtesy Light |
| *C | w/ Reflex Reflector Assembly | *D | w/ Cover |
| *1 | Wire Harness | - | - |
| *1 | RIVET | *2 | HOLE PLUG |
| ● | Non-reusable part | - | - |
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the power window regulator motor assembly removal/installation are shown below.
When the cable is disconnected/reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
Use the same procedure for the RH and LH sides.
Use the same procedure described for the LH side.
1. PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
for 1GR-FE:
for V35A-FTS:
4.REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL LH
67604 8.REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH
68174A 10.REMOVE REAR DOOR GLASS INNER WEATHERSTRIP LH
68199 11.REMOVE REAR DOOR REAR BELT SEAL LH
68152C 13.REMOVE REAR DOOR GLASS RUN LH
69804 17.REMOVE REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY LH
85720G 18.REMOVE POWER WINDOW REGULATOR MOTOR ASSEMBLY LH
Using a T25 "TORX" socket wrench, remove the 3 "TORX" screws and power window regulator motor assembly LH from the rear door window regulator sub-assembly LH.