| *A | for Driver Side | *B | for Front Passenger Side |
| *C | w/ Courtesy Light | *D | w/ Reflex Reflector Assembly |
| *E | w/ Cover | - | - |
| ● | Non-reusable part | - | - |
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the front door belt moulding assembly removal/installation are shown below.
When the cable is disconnected/reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
Use the same procedure for the RH and LH sides.
The procedure described below is for the LH side.
Use the same procedure for RHD and LHD vehicles.
The procedures listed below are for LHD vehicles.
1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
|
|
1GR-FE:
V35A-FTS:
3.REMOVE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)
4.REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)
67923E 9.REMOVE NO. 1 FRONT DOOR STIFFENER CUSHION
67602 10.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY
68172A 12.REMOVE FRONT DOOR GLASS INNER WEATHERSTRIP
67838D 13.REMOVE FRONT DOOR VENT SEAL
68151E 16.REMOVE FRONT DOOR GLASS RUN
75720 17.REMOVE FRONT DOOR BELT MOULDING ASSEMBLY LH
|
Remove in this Direction |
|
Push in this Direction |
Remove the front door belt moulding assembly LH by the following procedure.
1. Put protective tape around the front door belt moulding assembly LH.
2. Using moulding remover A, detach the claw as shown in the illustration.
3. Detach the claw and remove the front door belt moulding assembly LH in the order shown in the illustration.