| *A | for Standard | *B | for Full Cover Type |
Use the same procedure for the RH and LH sides.
The procedure described below is for the LH side.
76622D 1.REMOVE FRONT FENDER MUDGUARD LH
75602A 2.REMOVE FRONT FENDER MOULDING SUB-ASSEMBLY LH
Put protective tape around the front fender moulding sub-assembly LH.
Remove the 2 clips.
Detach the clip and remove the front fender moulding sub-assembly LH.
53806 3.REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH
|
Remove in this Direction |
|
Screw |
|
Clip | - | - |
4.REMOVE STEP SUB-ASSEMBLY LH (for Standard)
75860A 5.REMOVE BODY ROCKER PANEL MOULDING ASSEMBLY LH (for Standard)
|
Clip |
|
Screw |
Remove the 8 clips.
Remove the screw.
|
Place Hand Here |
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
|
Remove in this Direction (3) |
Put protective tape around the body rocker panel mouldling assembly LH.
Place your hand at the position shown in the illustration and pull in the direction indicated by the arrow to detach the vehicle rear side clip.
Place your hand at the position shown in the illustration and pull in the direction indicated by the arrow to detach the vehicle front side clip.
Place your hand at the position shown in the illustration and pull in the direction indicated by the arrow to detach the clip and remove the body rocker panel moulding assembly LH.
6.REMOVE STEP SUB-ASSEMBLY LH (for Full Cover Type)
51774C 7.REMOVE STEP PLATE COVER LH (for Full Cover Type)
| *A | w/ Step Light | - | - |
|
Screw |
|
Connector |
Remove the screw.
w/ Step Light
1. Disconnect the connector.
2. Detach the clamp.
Put protective tape around the step plate cover LH.
|
Remove in this Direction | - | - |
Using moulding remover A, detach the clip in the order shown in the illustration and remove the step plate cover LH.