| *A | w/ Panoramic View Monitor System | - | - |
When the front bumper is damaged or deformed due to an accident or contact with other objects, etc., or the bumper installation area on the body is repaired, it is necessary to perform millimeter wave radar sensor adjustment.
Target Adjustment (Triangle Target):
Target Adjustment (Flat Surface Target):
Driving Adjustment:
Click hereADAS / AD>ADVANCED DRIVER ASSISTANCE SYSTEM>MILLIMETER WAVE RADAR SENSOR>DRIVING ADJUSTMENT
When the front bumper is damaged or deformed due to an accident or contact with other objects, etc., or the bumper installation area on the body is repaired, it is necessary to perform ultrasonic sensor detection angle measurement.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING SUPPORT BRAKE SYSTEM>CALIBRATION
A bolt without a torque specification is shown in the standard bolt chart.
Click hereGeneral>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS
1. PRECAUTION
|
|
2.INSTALL FRONT BUMPER ASSEMBLY
51044 3.INSTALL ENGINE SIDE COVER SUB-ASSEMBLY LH
51043 4.INSTALL ENGINE SIDE COVER SUB-ASSEMBLY RH
75602A 5.INSTALL FRONT FENDER MOULDING SUB-ASSEMBLY LH
|
Clip |
|
Screw |
Attach the claw and clip and connect the front fender moulding sub-assembly LH.
Install the 2 clips.
Using a 4 mm hexagon socket wrench, install the screw.
75601A 6.INSTALL FRONT FENDER MOULDING SUB-ASSEMBLY RH
Use the same procedure described for LH side.
53292A 7.INSTALL UPPER RADIATOR SUPPORT SEAL
8. PERFORM CALIBRATION (w/ Panoramic View Monitor System)
9.ADJUST FOG LIGHT AIMING
Perform the following procedure only when removal of the fog light assembly.
Click hereVehicle Exterior>LIGHTING (EXT)>FOG LIGHT ASSEMBLY>ADJUSTMENT
10.ADJUST HEADLIGHT AIMING
Perform the following procedure only when removal of the headlight assembly.
Click hereVehicle Exterior>LIGHTING (EXT)>HEADLIGHT ASSEMBLY>ADJUSTMENT