| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | REAR NO. 1 SEAT ASSEMBLY RH | - | - | - | - |
| 2 | REAR NO. 1 SEAT ASSEMBLY LH | - | - | - | - |
| *A | w/ Child Restraint System Guide | - | - |
| *1 | NO. 1 SEATBACK COVER SUB-ASSEMBLY LH | *2 | HOG RING |
| ● | Non-reusable part | - | - |
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the rear seatback heater assembly LH removal/installation are shown below.
Wear protective gloves. Sharp areas on the parts may injure your hands.
There is risk of injury.
When the cable is disconnected/reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
Move both front seats to the frontmost position and fold them forward.
1.REMOVE REAR NO. 1 SEAT ASSEMBLY RH
2.REMOVE REAR NO. 1 SEAT ASSEMBLY LH
72329G 4.REMOVE REAR NO. 2 SEAT ADJUSTER BOLT COVER
72526L 5.REMOVE RECLINING ADJUSTER RELEASE HANDLE LH
72996H 7.REMOVE REAR SEATBACK COVER (w/ Child Restraint System Guide)
71702D 8.REMOVE REAR SEATBACK BOARD SUB-ASSEMBLY LH
71930Q 9.REMOVE REAR SEAT HEADREST SUPPORT ASSEMBLY
10.REMOVE SEPARATE TYPE REAR SEATBACK ASSEMBLY LH
87530 12.REMOVE REAR NO. 1 SEATBACK HEATER ASSEMBLY LH
Remove the tape and the rear No. 1 seatback heater assembly LH.
Do not reuse the rear No. 1 seatback heater assembly LH.
If the rear No. 1 seatback heater assembly LH is removed from the No. 1 seatback pad LH, replace the No. 1 seatback pad LH with new one.