Home › Vehicle Interior › SEAT › SEAT HEATER CONTROL (for Rear LH)
RM38G0E _58 Vehicle Interior _100628 SEAT _0468273 SEAT HEATER CONTROL(for Rear LH) A

SEAT  SEAT HEATER CONTROL(for Rear LH)  REMOVAL  


CAUTION / NOTICE / HINT

COMPONENTS (REMOVAL)
B622143N11
4.677,1.083 5.365,1.083 false 1.396,0.656 2.083,0.656 false 1.198,0.469 1.594,0.823 0.396,0.354 18 false 2 5.406,0.875 5.74,1.229 0.333,0.354 18 false 1

Procedure Part Name Code
Z101186

Z101188

Z101187

1 REAR NO. 1 SEAT ASSEMBLY RH - - - -
2 REAR NO. 1 SEAT ASSEMBLY LH - - - -

B622150N02
3.177,2.708 3.552,2.708 false 2.323,1 2.948,1 false 5.438,3.615 5.813,3.615 false 4.677,3.156 5.052,3.156 false 3.333,4.198 3.708,4.198 false 1.99,3.948 2.365,3.948 false 1.885,2.594 2.26,2.594 false 0.458,2.792 0.833,2.792 false 1.688,3.156 1.896,3.01 1.896,3.01 2.073,3.01 false 5.542,2.146 5.542,1.542 5.542,1.542 5.854,1.542 false 6.656,2.24 6.656,2.646 false 6.094,2.698 6.094,3.104 false 0.385,3.385 0.76,3.385 false 1.177,2.198 1.552,2.198 false 2.583,3.396 2.854,3.594 0.271,0.198 10 false x 9 1.802,4.448 2.073,4.646 0.271,0.198 10 false x 2 1.021,3.844 1.292,4.042 0.271,0.198 10 false x 2 2.104,0.823 2.469,1.104 0.365,0.281 18 false 3 6.021,3.094 6.385,3.375 0.365,0.281 18 false 5 6.208,1.354 6.573,1.635 0.365,0.281 18 false 6 5.885,3.458 6.25,3.74 0.365,0.281 18 false 7 2.115,2.854 2.479,3.135 0.365,0.281 18 false 8 0.302,2.615 0.667,2.896 0.365,0.281 18 false 9 2.292,2.417 2.656,2.698 0.365,0.281 18 false 10 1.594,2.01 1.958,2.292 0.365,0.281 18 false 11 2.385,3.792 2.75,4.073 0.365,0.281 18 false 12 0.073,3.198 0.438,3.479 0.365,0.281 18 false 13 3,4.01 3.365,4.292 0.365,0.281 18 false 14 2.844,2.542 3.208,2.823 0.365,0.281 18 false 16 6.573,2.635 6.938,2.917 0.365,0.281 18 false 4 5.073,2.958 5.438,3.24 0.365,0.281 18 false 15 0.365,3.042 0.635,3.24 0.271,0.198 10 false x 2

Procedure Part Name Code
Z101186

Z101188

Z101187

3 NO. 1 SEAT NO. 2 RECLINING COVER RH 71833V (Click here) - -
4 REAR NO. 2 SEAT ADJUSTER BOLT COVER 72329G - - -
5 RECLINING ADJUSTER RELEASE HANDLE LH 72526L - - -
6 REAR NO. 2 SEAT RECLINING COVER LH 71834X (Click here) - -
7 NO. 1 FOLD SEAT STOPPER BAND ASSEMBLY 78950F - - -
8 NO. 1 SEAT NO. 2 CUSHION COVER 79952A - - -
9 NO. 1 SEAT NO. 1 CUSHION COVER 79951B - - -
10 REAR NO. 1 SEAT NO. 4 LEG SIDE COVER 79967W - - -
11 REAR NO. 1 SEAT NO. 5 LEG SIDE COVER 79967X - - -
12 REAR NO. 1 SEAT HINGE SUB-ASSEMBLY LH 71302G - - -
13 REAR NO. 1 SEAT HINGE SUB-ASSEMBLY RH 71301H - - -
14 REAR SEAT CUSHION COVER LH 72998D - - -
15 REAR SEAT CUSHION UNDER COVER LH 72928E - - -
16 SEAT HEATER CONTROL SUB-ASSEMBLY LH 87501F - - -

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the seat heater control sub-assembly LH removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedures Effect/Inoperative Function When Necessary Procedures are not Performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point Parking assist monitor system (Click here)
Multi-terrain monitor system (Click here)
Panoramic view monitor system (Click here)

CAUTION:
B543257

·

Wear protective gloves. Sharp areas on the parts may injure your hands.

·

There is risk of injury.



HINT:
·

When the cable is disconnected/reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

-

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Stop and start system Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) (Click here)
Lighting system (EXT) Cornering lights Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 seconds or more. (Click here)
Pre-collision system
Lane tracing assist system
Lane departure alert system
Adaptive high beam system

-

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power back door system Fully close the back door by hand.
HINT:

Initialization is not necessary if the above procedures are performed while the back door is closed.


(Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor and expansion valve standard position is recognized. -


·

Move both front seats to the frontmost position and fold them forward.



PROCEDURE

Hide 2.REMOVE REAR NO. 1 SEAT ASSEMBLY LH

Hide 71833V 3.REMOVE NO. 1 SEAT NO. 2 RECLINING COVER RH

Z101186

Click here(Click here)

Hide 72329G 4.REMOVE REAR NO. 2 SEAT ADJUSTER BOLT COVER

Hide 72526L 5.REMOVE RECLINING ADJUSTER RELEASE HANDLE LH

Hide 71834X 6.REMOVE REAR NO. 2 SEAT RECLINING COVER LH

Z101186

Click here(Click here)

Hide 78950F 7.REMOVE NO. 1 FOLD SEAT STOPPER BAND ASSEMBLY

Hide 79952A 8.REMOVE NO. 1 SEAT NO. 2 CUSHION COVER

Hide 79951B 9.REMOVE NO. 1 SEAT NO. 1 CUSHION COVER

Hide 79967W 10.REMOVE REAR NO. 1 SEAT NO. 4 LEG SIDE COVER

Hide 79967X 11.REMOVE REAR NO. 1 SEAT NO. 5 LEG SIDE COVER

Hide 71302G 12.REMOVE REAR NO. 1 SEAT HINGE SUB-ASSEMBLY LH

Hide 71301H 13.REMOVE REAR NO. 1 SEAT HINGE SUB-ASSEMBLY RH

Hide 72998D 14.REMOVE REAR SEAT CUSHION COVER LH

Hide 72928E 15.REMOVE REAR SEAT CUSHION UNDER COVER LH

Hide 87501F 16.REMOVE SEAT HEATER CONTROL SUB-ASSEMBLY LH

a.
B611983