| *A | w/ Height Control Sensor | - | - |
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the rear upper arm removal/installation are shown below.
Use the same procedure for the RH and LH sides.
The following procedure is for the LH side.
1.REMOVE REAR WHEEL
89407B 2.REMOVE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY RH (w/ Height Control Sensor)
48790 4.REMOVE REAR UPPER CONTROL ARM ASSEMBLY LH
Hold the 2 nuts and remove the 2 bolts and rear upper control arm assembly LH.
48770A 5.REMOVE REAR UPPER CONTROL ARM ASSEMBLY RH
Use the same procedures described for the LH side.