The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the tilt and telescopic manual switch removal/installation are shown below.
When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1. PRECAUTION
3.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
for 1GR-FE:
for V35A-FTS:
45024 4.REMOVE LOWER STEERING COLUMN COVER SUB-ASSEMBLY
|
Push Area |
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
|
Remove in this Direction (3) |
Turn the steering wheel and remove the 3 screws.
Press the part in the direction of the arrow shown in the illustration to detach the claw.
Detach the 2 claws and remove the lower steering column cover in the direction of the arrow shown in the illustration.
Do not damage the tilt and telescopic switch.
89235A 5.REMOVE TILT AND TELESCOPIC SWITCH
| *a | Slider | - | - |
Slide the slider to release the lock, and then disconnect the yellow airbag connector from the spiral cable with sensor sub-assembly.
Refer to How to Connect or Disconnect Airbag Connector:
Disconnect the tilt and telescopic connector from the tilt and telescopic switch.
Disengage the claw and pull out the tilt and telescopic switch.