Home › Vehicle Interior › METER / GAUGE / DISPLAY › HEADUP DISPLAY SYSTEM
RM38G0E _58 Vehicle Interior _100611 METER / GAUGE / DISPLAY _0469279 HEADUP DISPLAY SYSTEM T

METER / GAUGE / DISPLAY  HEADUP DISPLAY SYSTEM  PROBLEM SYMPTOMS TABLE  


NOTICE:
·

When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.

·

When replacing the combination meter assembly, update the ECU security key.

Click hereGeneral>SETUP>WHEN REPLACING OR REMOVING/INSTALLING PARTS>UPDATE ECU SECURITY KEY



HINT:
·

Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptom are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.

·

Inspect the fuses related to this system before inspecting the suspected areas below.



Headup Display System
Symptom Suspected Area Link
Headup display is not displayed. Harness or connector -
Read the Data List (Display Change Switch) Click here
Meter mirror sub-assembly Click here
Combination meter assembly Click here
Brightness of the headup display does not change. Perform Active Test (Display Brightness) Click here
Read the Data List (Brightness Up Switch, Brightness Down Switch) Click here
Meter mirror sub-assembly Click here
Headup display is not displayed in the correct position. Perform Active Test (Display Position) Click here
Read the Data List (Projection Position Up Switch, Projection Position Down Switch ) Click here
Meter mirror sub-assembly Click here
Other headup display malfunction (Other systems are normal) Meter mirror sub-assembly Click here