Depending on the malfunction, the skid control ECU prohibits operation of the electronically controlled brake system to protect components and prevent incorrect operation when DTCs are stored.
If the switching solenoid is disabled due to prohibition of the electronically controlled brake system, the response of the brake pedal changes and braking performance is reduced.
After replacing the No. 1 skid control ECU (brake booster with master cylinder assembly), perform "Calibration".
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>UTILITY
Check the conditions at the time the problem occurred.
Whether a warning light illuminated or the buzzer sounded.
Road surface condition when the problem occurred and just before the problem occurred.
When the problem occurred and how many times the brake pedal was depressed before the problem occurred.
Frequency of the abnormal brake pedal response.
| Proceed to |
|---|
| NEXT |
NEXT
Using the GTS, check DTCs and Freeze Frame Data.
If there are currently no warnings and the brake pedal travel is not excessive, DTCs may have been cleared after the system returned to normal.
If the brake pedal response returned to normal and there are currently no warnings, the system is normal.
| Result | Proceed to |
|---|---|
| DTCs are not output. | A |
| DTCs are output. | B |
A
B
While depressing the brake pedal by hand, check the installation condition of the brake pedal stroke sensor assembly and brake pedal, and check for mechanical malfunctions.
Check and adjust the brake pedal height.
for LHD: Click hereBrake>BRAKE SYSTEM (OTHER)>BRAKE PEDAL (for LHD)>ADJUSTMENT
for RHD: Click hereBrake>BRAKE SYSTEM (OTHER)>BRAKE PEDAL (for RHD)>ADJUSTMENT
| Proceed to |
|---|
| NEXT |
NEXT
Click hereBrake>BRAKE SYSTEM (OTHER)>BRAKE SYSTEM>ON-VEHICLE INSPECTION
The brake booster with master cylinder assembly is normal.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG
for LHD: Click hereBrake>BRAKE SYSTEM (OTHER)>BRAKE BOOSTER (for LHD)>REMOVAL
for RHD: Click hereBrake>BRAKE SYSTEM (OTHER)>BRAKE BOOSTER (for RHD)>REMOVAL