| *A | for Driver Side | *B | for Front Passenger Side |
| *C | w/ Courtesy Light | *D | w/ Cover |
| *E | w/ Reflex Reflector Assembly | - | - |
|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft.*lbf) | - | - |
Use the same procedure for the LHD and RHD vehicles.
The procedure listed below is for the LHD vehicles.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
8983AA 1.INSTALL SIDE AIRBAG PRESSURE SENSOR LH
| *a | Turns off | - | - |
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
Wait at least 60 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.
Connect the airbag connector.
When connecting any airbag connector, take care not to damage the airbag wire harness.
Refer to How to Connect or Disconnect Airbag Connector: Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>HOW TO CONNECT OR DISCONNECT AIRBAG CONNECTOR
Engage the claw to hold the side airbag pressure sensor LH in place.
If the side airbag pressure sensor LH has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.
When installing the side airbag pressure sensor LH, make sure that the wire harness does not interfere with or is not pinched between other parts.
Make sure that the side airbag pressure sensor LH claw is securely inserted into the door hole.
Waterproof rubber seal that are damaged on the side airbag pressure sensor LH cannot be reused.
Keep the stud bolt and waterproof rubber seal free of foreign matter.
Install the side airbag pressure sensor LH with the nut.
Check that there is no looseness in the installation parts of the side airbag pressure sensor LH.
67602 3.INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH
67923E 4.INSTALL NO. 1 FRONT DOOR STIFFENER CUSHION
67811C 5.INSTALL FRONT DOOR HOLE COVER (w/ Cover)
81580C 6.INSTALL REFLEX REFLECTOR ASSEMBLY (w/ Reflex Reflector Assembly)
81230 7.INSTALL COURTESY LIGHT ASSEMBLY (w/ Courtesy Light)
74222A 8.INSTALL FRONT DOOR ARMREST COVER LH
9.INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)
10.INSTALL MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)
67782 11.INSTALL FRONT DOOR TRIM UPPER COVER
12.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
for 1GR-FE:
for V35A-FTS:
13. PERFORM DIAGNOSTIC SYSTEM CHECK
14.CHECK SRS WARNING LIGHT
15. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE
When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART