| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | NO. 1 ENGINE UNDER COVER ASSEMBLY | 51410 | - | - | - |
| 2 | NO. 2 ENGINE UNDER COVER ASSEMBLY | 51420 | - | - | - |
| *1 | ENGINE SIDE COVER SUB-ASSEMBLY LH | *2 | ENGINE SIDE COVER SUB-ASSEMBLY RH |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 3 | DRAIN ENGINE OIL | - | - | ( ) |
- |
| 4 | ENGINE OIL LEVEL SENSOR | 89491 | ( ) |
- | - |
| ● | Non-reusable part | - | - |
51410 1.REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY
|
Bolt A |
|
Bolt B |
|
Remove in this Direction | - | - |
Remove the 5 bolts (A) and 4 bolts (B).
Move the side of No. 1 engine under cover assembly facing the front of the vehicle toward the LH side and detach the temporary holding guide.
Remove the No. 1 engine under cover assembly facing the front of the vehicle while pulling the engine side cover sub-assembly RH and engine side cover sub-assembly LH, and then remove the No. 1 engine under cover assembly while detaching the 2 temporary holding guides facing the rear of the vehicle as shown in the illustration.
51420 2.REMOVE NO. 2 ENGINE UNDER COVER ASSEMBLY
3.DRAIN ENGINE OIL
89491 4.REMOVE ENGINE OIL LEVEL SENSOR
| *1 | Cutting Position | *2 | Supply Part |
Disconnect the connector.
Remove the 4 bolts and engine oil level sensor.
Cut away part of the gasket and remove the gasket from the engine oil level sensor.
Remove only the outer part of the gasket.