| *1 | POWER STEERING OIL PRESSURE SWITCH CONNECTOR | *2 | WIRE HARNESS CLAMP BRACKET |
| *3 | VENTILATION HOSE | *4 | VACUUM HOSE |
|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft.*lbf) |
|
N*m (kgf*cm, ft.*lbf) : Specified torque |
| ● | Non-reusable part | - | - |
44310 1.INSTALL VANE PUMP ASSEMBLY
Install the vane pump assembly with the 2 bolts.
Tighten the bolts in the following sequence: Temporarily install in the order of A to B and fully tighten in the order of A to B.
Install the wire harness clamp bracket to the vane pump assembly with the bolt.
44410 2.CONNECT PRESSURE FEED TUBE ASSEMBLY
44348A 3.CONNECT NO. 1 OIL RESERVOIR TO PUMP HOSE
| *a | Clip Positioning Area | *b | 29 mm (1.14 in.) |
| *c | 12 mm (0.472 in.) | *d | 3 to 9 mm (0.118 to 0.354 in.) |
Connect the No. 1 oil reservoir to pump hose to the vane pump assembly and slide the hose clip to secure it.
Align the hose and the hose clip at the locations shown in the illustration and install them.
16361A 4.INSTALL FAN AND GENERATOR V BELT
17700 5.INSTALL AIR CLEANER ASSEMBLY WITH AIR CLEANER HOSE ASSEMBLY
6.ADD POWER STEERING FLUID
7.BLEED POWER STEERING FLUID
8.CHECK FOR POWER STEERING FLUID LEAKAGE