| *1 | SUSPENSION CONTROL TUBE | *2 | FRONT STABILIZER BRACKET |
|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft.*lbf) | * | For use with a union nut wrench |
| ● | Non-reusable part | - | - |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 7 | FRONT STABILIZER HOUSING SUB-ASSEMBLY | 48006 | ( ) |
- | - |
| 8 | FRONT FENDER APRON TRIM PACKING A | 53782 | ( ) |
- | - |
| 9 | FRONT FENDER APRON TRIM PACKING C | 53784 | ( ) |
- | - |
| 10 | FRONT WHEEL | - | - | - | - |
48878 1.INSTALL FRONT STABILIZER CONTROL CYLINDER LH
|
|
| *1 | Suspension Control Tubes | - | - |
|
Install in this Direction | - | - |
Connect the front stabilizer control cylinder LH as shown in the illustlation.
Install the front stabilizer control cylinder LH with 4 bolts (A).
Connect the 2 suspension control tubes with 2 new gaskets and 2 bolts (B).
48876 2.INSTALL FRONT STABILIZER CONTROL CYLINDER
|
|
| *1 | Suspension Control Tubes | - | - |
| *a | Torque Wrench Fulcrum Length | *b | Union Nut Wrench |
|
Install in this Direction | - | - |
Connect the front stabilizer control cylinder as shown in the illustlation.
Install the front stabilizer control cylinder with 4 bolts.
Using a union nut wrench, connect the 2 suspension control tubes.
Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
When using a union nut wrench (fulcrum length of 30 mm (1.181 in.)) + torque wrench (fulcrum length of 255 mm (10.039 in.)): 39.5 N*m (403 kgf*cm, 29 ft.*lbf)
48811 3.INSTALL FRONT STABILIZER BAR
48806C 4.INSTALL FRONT CENTER STABILIZAR BRACE SUB-ASSEMBLY
48810 5.INSTALL FRONT STABILIZER LINK ASSEMBLY LH
48820B 6.INSTALL FRONT STABILIZER LINK ASSEMBLY RH
Use the same procedure described for the LH side.
48006 7.INSTALL FRONT STABILIZER HOUSING SUB-ASSEMBLY
|
|
Click hereSuspension>SUSPENSION CONTROL>STABILIZER CONTROL VALVE (for Front Side)>INSTALLATION
53782 8.INSTALL FRONT FENDER APRON TRIM PACKING A
|
|
for V35A-FTS: Click hereEngine / Hybrid System>V35A-FTS (ENGINE MECHANICAL)>ENGINE ASSEMBLY>INSTALLATION
for 1GR-FE: Click hereEngine / Hybrid System>1GR-FE (ENGINE MECHANICAL)>ENGINE ASSEMBLY>INSTALLATION
53784 9.INSTALL FRONT FENDER APRON TRIM PACKING C
|
|
for V35A-FTS: Click hereEngine / Hybrid System>V35A-FTS (ENGINE MECHANICAL)>ENGINE ASSEMBLY>INSTALLATION
for 1GR-FE: Click hereEngine / Hybrid System>1GR-FE (ENGINE MECHANICAL)>ENGINE ASSEMBLY>INSTALLATION
10.INSTALL FRONT WHEEL