| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | FRONT WHEEL | - | - | - | - |
| 2 | FRONT FENDER APRON TRIM PACKING A | 53782 | ( ) |
- | - |
| 3 | FRONT FENDER APRON TRIM PACKING C | 53784 | ( ) |
- | - |
| 4 | FRONT STABILIZER HOUSING SUB-ASSEMBLY | 48006 | ( ) |
- | - |
| *1 | SUSPENSION CONTROL TUBE | *2 | FRONT STABILIZER BRACKET |
| - | - | - | - |
| ● | Non-reusable part | - | - |
1.REMOVE FRONT WHEEL
53782 2.REMOVE FRONT FENDER APRON TRIM PACKING A
|
|
for V35A-FTS: Click hereEngine / Hybrid System>V35A-FTS (ENGINE MECHANICAL)>ENGINE ASSEMBLY>REMOVAL
for 1GR-FE: Click hereEngine / Hybrid System>1GR-FE (ENGINE MECHANICAL)>ENGINE ASSEMBLY>REMOVAL
53784 3.REMOVE FRONT FENDER APRON TRIM PACKING C
|
|
for V35A-FTS: Click hereEngine / Hybrid System>V35A-FTS (ENGINE MECHANICAL)>ENGINE ASSEMBLY>REMOVAL
for 1GR-FE: Click hereEngine / Hybrid System>1GR-FE (ENGINE MECHANICAL)>ENGINE ASSEMBLY>REMOVAL
48006 4.REMOVE FRONT STABILIZER HOUSING SUB-ASSEMBLY
|
|
Click hereSuspension>SUSPENSION CONTROL>STABILIZER CONTROL VALVE (for Front Side)>REMOVAL
48810 5.REMOVE FRONT STABILIZER LINK ASSEMBLY LH
Remove the 2 nuts and front stabilizer link assembly LH.
If the ball joint turns together with the nut, use a 8 mm hexagon wrench to hold the stud in place.
48820B 6.REMOVE FRONT STABILIZER LINK ASSEMBLY RH
|
|
48806C 7.REMOVE FRONT CENTER STABILIZAR BRACE SUB-ASSEMBLY
48811 8.REMOVE FRONT STABILIZER BAR
48878 9.REMOVE FRONT STABILIZER CONTROL CYLINDER LH
|
|
| *1 | Suspension Control Tubes | - | - |
|
Remove in this Direction | - | - |
Remove the 2 bolts and disconnect the 2 suspension control tubes from the front stabilizer control cylinder LH.
Remove the 2 gaskets.
Remove the 4 bolts.
Remove the front stabilizer control cylinder LH as shown in the illustlation.
48876 10.REMOVE FRONT STABILIZER CONTROL CYLINDER
|
|
| *1 | Suspension Control Tubes | - | - |
|
Remove in this Direction | - | - |
Using a union nut wrench, disconnect the 2 suspension control tubes from the front stabilizer cylinder.
Remove the 4 bolts.
Remove the front stabilizer control cylinder as shown in the illustlation.