| *1 | NO. 3 WATER BY-PASS HOSE | - | - |
|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft.*lbf) |
|
N*m (kgf*cm, ft.*lbf): Specified torque |
| ● | Non-reusable part | - | - |
| *1 | ENGINE SIDE COVER SUB-ASSEMBLY LH | *2 | ENGINE SIDE COVER SUB-ASSEMBLY RH |
| *3 | OIL FILLER CAP ASSEMBLY | - | - |
|
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
This procedure includes the installation of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
1.INSTALL OIL COOLER O-RING
15785 2.INSTALL OIL COOLER GASKET
15710 3.INSTALL OIL COOLER ASSEMBLY
16603B 4.INSTALL IDLER PULLEY SUB-ASSEMBLY
15674 5.INSTALL OIL FILTER RECEIVER
Using an 8 mm socket wrench, install the oil filter receiver with the 2 bolts.
Attach the clamp.
15601 6.INSTALL OIL FILTER SUB-ASSEMBLY
88310A 7.INSTALL NO. 1 V BELT (COOLER COMPRESSOR TO CRANKSHAFT PULLEY)
8.ADD ENGINE OIL
9.ADD ENGINE COOLANT
10.INSPECT ENGINE OIL LEVEL
11.INSPECT FOR OIL LEAK
12.INSPECT FOR COOLANT LEAK
51455C 13.INSTALL NO. 2 ENGINE UNDER COVER SEAL
51410 14.INSTALL NO. 1 ENGINE UNDER COVER ASSEMBLY