| *1 | NO. 2 CONSOLE BOX RETAINER | - | - |
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1.SECURE VEHICLE
Fully apply the parking brake and chock a wheel.
Make sure to apply the parking brake and chock a wheel before performing this procedure.
If the vehicle is not secure and the shift lever is moved to N, the vehicle may suddenly move, possibly resulting in an accident or serious injury.
5.REMOVE UPPER CONSOLE PANEL ASSEMBLY
33820B 6.DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY
|
|
| *a | Clip | *b | 45° to 60° |
| *c | Lock Piece | *d | Adjuster Case |
|
Pull Up | - | - |
Remove the 2 screws and the No. 2 console box retainer from the rear console box sub-assembly.
Using 2 screwdrivers, pull up the lock piece from the adjuster case.
While disengaging the clip as shown in the illustration, disconnect the transmission control cable assembly from the floor shift lever assembly together with the clip.
|
Pull Out |
|
Remove in this Direction |
|
Rotate approximately 180° | - | - |
Pull out the cable locks of the transmission control cable assembly.
Rotate the lock nut counterclockwise approximately 180° and, while holding the lock nut in that position, disconnect the transmission control cable assembly from the floor shift assembly.
Do not over-rotate the nut as it will come off the internal spring and the transmission control cable assembly will not be reusable.
7.REMOVE FLOOR SHIFT LEVER ASSEMBLY
|
|
|
Connector |
|
Bolt |