Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ELECTRONICALLY CONTROLLED BRAKE SYSTEM
RM38G0E _54 Brake _100463 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0469467 ELECTRONICALLY CONTROLLED BRAKE SYSTEM C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ELECTRONICALLY CONTROLLED BRAKE SYSTEM  C007800  Different Diameter Tire  


DESCRIPTION

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from Note
C007800 Different Diameter Tire The vehicle speed exceeds 20 km/h (12 mph) and a difference exceeding 20% between the value output from the speed sensors of the front wheels and the rear wheels occurs the specified number of times or more.
·

Incorrect tire size

·

Tire air pressure not adjusted correctly

·

Speed sensor system

·

No. 2 skid control ECU (brake actuator assembly)


Brake/EPB Output ECU: No. 2 skid control ECU (brake actuator assembly)

CAUTION / NOTICE / HINT

NOTICE:

After replacing the No. 2 skid control ECU (brake actuator assembly), perform "Calibration".

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>UTILITY


PROCEDURE

1.CHECK TIRE SIZE
a.

Check the tire sizes to ensure that the front and rear tire sizes are not different.

Click hereSuspension>TIRE / WHEEL>TIRE AND WHEEL SYSTEM>INSPECTION

HINT:

If different tire sizes are discovered, replace the tires so that the tire sizes are the same on all 4 wheels.



b.

Adjust the air pressure in the tires.

Click hereSuspension>TIRE / WHEEL>TIRE AND WHEEL SYSTEM>INSPECTION


Result:
Proceed to
NEXT



NEXT

2.RECONFIRM DTC
2.RECONFIRM DTC
a.

Clear the DTCs.

Chassis > Brake/EPB > Clear DTCs
50002 435

b.

Turn the ignition switch off.


c.

Start the engine.


d.

Drive the vehicle at a constant speed of 30 km/h (19 mph) or higher for several minutes.


e.

Check if the same DTC is output.

Chassis > Brake/EPB > Trouble Codes
50001 435

f.

Check that no electronically controlled brake system speed sensor DTCs are output.

Chassis > Brake/EPB > Trouble Codes
50001 435
HINT:
·

If C007800 and electronically controlled brake system DTCs are output simultaneously, check and repair the trouble areas in the electronically controlled brake system.

·

When a DTC has been stored, the vehicle condition when the DTC was stored can be determined from the freeze frame data.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>FREEZE FRAME DATA



Result:
Result Proceed to
DTCs are not output A
Electronically controlled brake system speed sensor DTCs are output B
Only C007800 is output C




A

B

REPAIR CIRCUITS INDICATED BY OUTPUT DTCS

C