| *1 | DUST COVER | *2 | IDLE PULLEY SUB-ASSEMBLY |
| *3 | IDLE PULLEY COLLAR | - | - |
|
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
16100 1.INSTALL ENGINE WATER PUMP ASSEMBLY
|
Bolt A |
|
Bolt B |
|
Nut | - | - |
Install a new engine water pump gasket.
Temporarily install the engine water pump assembly with the 10 bolts and 2 nuts.
| Item | Length |
|---|---|
| Bolt A | 30 mm (1.18 in.) |
| Bolt B | 80 mm (3.15 in.) |
Uniformly tighten the 10 bolts and 2 nuts of the engine water pump assembly in the order shown in the illustration.
16571E 2.CONNECT WATER HOSE
| *a | Paint Mark | *b | Stopper |
| *c | 0 to 2.0 mm (0 to 0.0787 in.) | *d | 2.0 to 6.0 mm (0.0787 to 0.236 in.) |
| *e | 90° | *f | Upper Side |
| *g | Front Side | - | - |
Connect the water hose to the engine water pump assembly and slide the hose clip to secure it as shown in the illustration.
Make sure the water hose is securely inserted to the stopper.
16630J 3.INSTALL NO. 2 IDLER PULLEY ASSEMBLY
16604C 4.INSTALL NO. 2 IDLER PULLEY SUB-ASSEMBLY
16331A 5.INSTALL THERMOSTAT