| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | THERMOSTAT | 16331A | ( ) |
- | - |
| 2 | WATER INLET | 16321 | ( ) |
- | - |
| 3 | V-RIBBED BELT TENSIONER ASSEMBLY | 16620D | - | - | - |
|
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
| *1 | HEATER WATER PIPE B | *2 | DUST COVER |
| *3 | IDLE PULLEY SUB-ASSEMBLY | *4 | IDLE PULLEY COLLAR |
|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft.*lbf) |
|
N*m (kgf*cm, ft.*lbf): Specified torque |
| *1 | FLUID COUPLING ASSEMBLY WITH FAN | *2 | FAN PULLEY |
|
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
| *1 | ENGINE SIDE COVER SUB-ASSEMBLY LH | *2 | ENGINE SIDE COVER SUB-ASSEMBLY RH |
|
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
16331A 1.INSTALL THERMOSTAT
| *1 | Gasket | - | - |
| *a | OK | *b | NG |
| *c | Upper Side | *d | 15° |
| *e | Jiggle Valve | - | - |
Install a new gasket to the thermostat.
When installing the gasket to the thermostat, be careful not to deform the gasket. Make sure that the groove of the gasket is properly installed to the thermostat as shown in the illustration.
Insert the thermostat into the engine water pump assembly with the jiggle valve facing straight upward.
The jiggle valve may be set to within 15° on either side of the prescribed position.
16321 2.INSTALL WATER INLET
|
Bolt A |
|
Bolt B |
Install the water inlet to the engine assembly with the 4 bolts.
Tightening order: Temporarily install bolt A → Temporarily install bolt B → Tighten bolt A → Tighten bolt B
16620D 3.INSTALL V-RIBBED BELT TENSIONER ASSEMBLY
16630H 4.INSTALL IDLER PULLEY ASSEMBLY
16604C 5.INSTALL NO. 2 IDLER PULLEY SUB-ASSEMBLY
82121 9.CONNECT ENGINE WIRE
16278 12.CONNECT NO. 2 WATER BY-PASS PIPE
16361A 19.INSTALL FAN AND GENERATOR V BELT
20.ADD ENGINE COOLANT
21.ADD COOLANT (for Intercooler)
22.INSPECT FOR COOLANT LEAK
23.INSPECT FOR COOLANT LEAK (for Intercooler)
51410 24.INSTALL NO. 1 ENGINE UNDER COVER ASSEMBLY
12601B 25.INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY