Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › KNEE AIRBAG ASSEMBLY (for Driver Side) › from 2021.07
RM38G0E _58 Vehicle Interior _100751 SUPPLEMENTAL RESTRAINT SYSTEMS _0467880 KNEE AIRBAG ASSEMBLY(for Driver Side) A

SUPPLEMENTAL RESTRAINT SYSTEMS  KNEE AIRBAG ASSEMBLY(for Driver Side)  REMOVAL  


CAUTION / NOTICE / HINT

COMPONENTS (REMOVAL)
B664763N01
4.885,0.75 5.26,0.75 true 4.51,1.281 4.51,1.531 true 6.552,0.302 6.802,0.302 true 6.51,0.719 6.76,0.719 true 2.865,1.135 2.865,1.365 true 2.646,2.052 2.646,2.302 true 3.354,2.917 3.354,3.146 true 2.177,2.188 2.177,2.438 true 2.292,0.885 2.292,1.135 true 1.583,3.365 1.333,3.365 true 0.927,2.24 0.677,2.24 true 0.948,0.823 0.688,0.823 true 2.927,1.667 2.927,1.917 true 3.375,0.469 3.635,0.469 true 6.417,0.135 6.698,0.49 0.281,0.354 18 false 1 6.354,0.542 6.635,0.896 0.281,0.354 18 false 2 3.948,3.198 4.406,3.396 0.458,0.198 10 false x 2 2.969,1.531 3.427,1.729 0.458,0.198 10 false x 2 3.667,1.844 4.125,2.042 0.458,0.198 10 false x 4 1.615,3.208 1.896,3.563 0.281,0.354 18 false 4 3.281,3.104 3.563,3.458 0.281,0.354 18 false 3 0.948,2.083 1.229,2.438 0.281,0.354 18 false 5 1.229,0.677 1.51,1.031 0.281,0.354 18 false 6 2.229,1.104 2.51,1.458 0.281,0.354 18 false 7 5.531,0.667 5.813,1.021 0.281,0.354 18 false 8 4.448,1.49 4.729,1.844 0.281,0.354 18 false 9 3.865,0.323 4.313,0.677 0.448,0.354 18 false 10 2.729,0.885 3.344,1.24 0.615,0.354 18 false 11 2.052,2.396 2.927,2.76 0.875,0.365 18 false 12 2.51,2.25 3.177,2.615 0.667,0.365 18 false 13 2.792,1.875 3.333,2.344 0.542,0.469 18 false 14

Procedure Part Name Code
Z101186

Z101188

Z101187

1 PRECAUTION - (Click here) - -
2 DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL - (Click here) - -
3 NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY 55606 (Click here) - -
4 FRONT DOOR SCUFF PLATE LH 67914B - - -
5 COWL SIDE TRIM BOARD LH 62112 - - -
6 NO. 2 INSTRUMENT SIDE PANEL 55318F (Click here) - -
7 LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL 55432D (Click here) - -
8 INTEGRATION CONTROL AND PANEL SUB-ASSEMBLY 84012 (Click here) - -
9 INNER NO. 1 INSTRUMENT PANEL BRACKET COVER LH 55395C - - -
10 LOWER INSTRUMENT PANEL 55312 (Click here) - -
11 LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY 73900 (Click here) - -
12 FUEL LID LOCK OPEN LEVER SUB-ASSEMBLY 77306 - - -
13 HOOD LOCK CONTROL LEVER SUB-ASSEMBLY 53601 - - -
14 GROMMET - - - -

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the lower No. 1 instrument panel airbag assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedures Effect/Inoperative Function When Necessary Procedures are not Performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point Parking assist monitor system (Click here)
Multi-terrain monitor system (Click here)
Panoramic view monitor system (Click here)

HINT:
·

When the cable is disconnected/reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

-

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Stop and start system Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) (Click here)
Lighting system (EXT) Cornering lights Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 seconds or more. (Click here)
Pre-collision system
Lane tracing assist system
Lane departure alert system
Adaptive high beam system

-

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power back door system Fully close the back door by hand.
HINT:

Initialization is not necessary if the above procedures are performed while the back door is closed.


(Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor and expansion valve standard position is recognized. -


·

Use the same procedure for the LHD and RHD vehicles.

·

The procedure listed below is for the LHD vehicles.



PROCEDURE

Hide 1. PRECAUTION

Z101186

CAUTION:
B475753

Be sure to read precaution thoroughly before servicing.

Click here(Click here)


NOTICE:

After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) battery terminal.

Click here(Click here)



Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Z101186

CAUTION:
B422343

·

Wait at least 60 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

·

If the airbag deploys for any reason, it may cause a serious accident.





Hide 55606 3.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Z101186

Click here(Click here)

Hide 67914B 4.REMOVE FRONT DOOR SCUFF PLATE LH

Hide 62112 5.REMOVE COWL SIDE TRIM BOARD LH

Hide 55318F 6.REMOVE NO. 2 INSTRUMENT SIDE PANEL

Z101186

Click here(Click here)

Hide 55432D 7.REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL

Z101186

Click here(Click here)

Hide 84012 8.REMOVE INTEGRATION CONTROL AND PANEL SUB-ASSEMBLY

Z101186

Click here(Click here)

Hide 55395C 9.REMOVE INNER NO. 1 INSTRUMENT PANEL BRACKET COVER LH

Hide 55312 10.REMOVE LOWER INSTRUMENT PANEL

Z101186

Click here(Click here)

Hide 73900 11.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

Z101186

CAUTION:
·
B528852N02
1.563,1.885 1.563,1.635 false 1.51,1.906 1.823,2.104 0.313,0.198 10 false *a

When storing the lower No. 1 instrument panel airbag assembly, keep the airbag deployment side (*a) facing upward.

·

If the airbag deploys for any reason, it may cause a serious accident.




a.
B608600C01
0.583,0.667 1.167,0.667 true 4.208,0.094 4.531,0.417 0.323,0.323 18 false ii 0.438,0.563 0.708,0.771 0.271,0.208 10 false *a 0.625,0.094 0.948,0.417 0.323,0.323 18 false i
*a Turns off - -


i.

Check that the ignition switch is off.


ii.

Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:
·

Wait at least 60 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

·

If the airbag deploys for any reason, it may cause a serious accident.





b.
B608757N01
2.354,0.031 2.635,0.385 0.281,0.354 18 false i 3.854,2.063 4.135,2.417 0.281,0.354 18 false iii 0.438,2.063 0.719,2.417 0.281,0.354 18 false ii

i.

Disconnect the airbag connector.

NOTICE:

When disconnecting any airbag connector, take care not to damage the airbag wire harness.


HINT:

Refer to How to Connect or Disconnect Airbag Connector: Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>HOW TO CONNECT OR DISCONNECT AIRBAG CONNECTOR



ii.

Remove the 4 bolts.


iii.

Disengage the claw to remove the lower No. 1 instrument panel airbag assembly.



Hide 77306 12.REMOVE FUEL LID LOCK OPEN LEVER SUB-ASSEMBLY

a.
B608755


Hide 53601 13.REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

a.
B608756


Hide 14.REMOVE GROMMET

a.
B608759