|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft.*lbf) | - | - |
Use the same procedure for the LHD and RHD vehicles.
The procedure listed below is for the LHD vehicles.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
89174A 1.INSTALL FRONT AIRBAG SENSOR LH
| *a | Turns off | - | - |
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
Wait at least 60 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.
Perform the following procedure to install the front airbag sensor LH.
1. Connect the airbag connector.
When connecting any airbag connector, take care not to damage the airbag wire harness.
Refer to How to Connect or Disconnect Airbag Connector: Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>HOW TO CONNECT OR DISCONNECT AIRBAG CONNECTOR
2. Engage the claw to hold the front airbag sensor LH in place.
If the front airbag sensor LH has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.
When installing the front airbag sensor LH, make sure that the wire harness does not interfere with or is not pinched between other parts.
Make sure that the front airbag sensor LH claw is securely inserted into the body hole.
3. Install the front airbag sensor LH with the bolt.
Tighten the bolt while holding the front airbag sensor LH because the front airbag sensor LH claw is easily damaged.
4. Check that there is no looseness in the installation parts of the front airbag sensor LH.
2.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
for 1GR-FE:
for V35A-FTS:
for F33A-FTV:
3. PERFORM DIAGNOSTIC SYSTEM CHECK
4.CHECK SRS WARNING LIGHT
5. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE
When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART