Home › Vehicle Interior › SEAT › OCCUPANT DETECTION SENSOR (for 40/20/40 Split Seat Type RH Side) › from 2021.07
RM38G0E _58 Vehicle Interior _100628 SEAT _0484644 OCCUPANT DETECTION SENSOR(for 40/20/40 Split Seat Type RH Side) A

SEAT  OCCUPANT DETECTION SENSOR(for 40/20/40 Split Seat Type RH Side)  REMOVAL  


CAUTION / NOTICE / HINT

COMPONENTS (REMOVAL)
B622144N01
4.042,1.042 4.656,1.042 false 4.719,0.875 5,1.229 0.281,0.354 18 false 1

Procedure Part Name Code
Z101186

Z101188

Z101187

1 REAR NO. 1 SEAT ASSEMBLY RH - - - -

B622399N01
0.094,0.083 2.635,3.531 2.542,3.448 0.156,1.073 2.583,2.021 2.427,0.948 6.813,1.542 6.813,1.25 false 6.625,5.24 6.625,4.76 false 1.625,1.448 1.625,1.292 1.625,1.292 1.865,1.292 false 1.688,0.365 2.167,0.365 false 5.969,0.823 5.969,0.385 5.969,0.385 6.24,0.385 false 2.969,1.365 2.969,0.719 2.969,0.719 3.24,0.719 false 3.76,0.76 3.958,0.302 3.958,0.302 4.26,0.302 false 2.969,1.885 2.969,1.625 2.969,1.625 3.229,1.625 false 4.281,4.708 4.281,4.229 false 3.635,5.281 3.635,4.938 false 5.563,4.49 5.115,4.49 false 5.906,3.521 5.458,3.521 false 6.469,3.104 6.021,3.104 false 6.229,2.854 5.781,2.854 false 1.698,3.656 1.25,3.656 false 2.375,4.135 2.073,4.135 false 2.573,4.719 2.125,4.719 false 0.875,4.167 0.427,4.167 false 2.521,5.104 2.073,5.104 false 0.865,4.51 0.417,4.51 false 2.938,0.354 2.635,0.354 false 0.552,2.958 0.552,2.552 false 2.25,3.292 2.021,3.292 false 2.219,0.271 2.531,0.469 0.313,0.198 10 false *1 1.302,4.927 1.615,5.125 0.313,0.198 10 false x 2 1.958,5.5 2.271,5.698 0.313,0.198 10 false x 2 2.833,3.969 3.146,4.167 0.313,0.198 10 false x 9 6.635,5.281 6.99,5.563 0.354,0.281 18 false 2 4.354,0.135 4.708,0.417 0.354,0.281 18 false 3 3.302,0.583 3.656,0.865 0.354,0.281 18 false 4 3,1.906 3.354,2.188 0.354,0.281 18 false 5 4.927,4.313 5.281,4.594 0.354,0.281 18 false 6 2.646,4.583 3,4.865 0.354,0.281 18 false 7 1.729,3.542 2.083,3.823 0.354,0.281 18 false 9 0.26,4.031 0.615,4.313 0.354,0.281 18 false 8 2.438,4 2.792,4.281 0.354,0.281 18 false 9 2.531,4.969 2.885,5.25 0.354,0.281 18 false 10 0.125,4.365 0.479,4.646 0.354,0.281 18 false 11 3.51,5.292 3.865,5.573 0.354,0.281 18 false 12 4.135,4.729 4.49,5.01 0.354,0.281 18 false 13 6.26,2.688 6.615,2.969 0.354,0.281 18 false 15 6.677,1.552 7.031,1.833 0.354,0.281 18 false 17 5.115,3.354 5.469,3.635 0.354,0.281 18 false 14 6.26,0.24 6.615,0.521 0.354,0.281 18 false 18 3.25,0.188 3.594,0.469 0.344,0.281 18 false 19 2.25,1.167 2.604,1.448 0.354,0.281 18 false 21 2.292,3.188 2.604,3.385 0.313,0.198 10 false ●*2 6.5,2.948 6.854,3.229 0.354,0.281 18 false 16 0.552,2.99 0.969,3.271 0.417,0.281 18 false 20 2.156,1.188 2.469,1.385 0.313,0.198 10 false ● 0.906,5.177 1.219,5.375 0.313,0.198 10 false x 2 0.469,3.01 0.625,3.208 0.156,0.198 10 false ● 1.896,3.333 2.208,3.531 0.313,0.198 10 false x 12 0.208,1.115 0.521,1.313 0.313,0.198 12 false *A

Procedure Part Name Code
Z101186

Z101188

Z101187

2 REAR NO. 1 SEAT RECLINING COVER LH 71834S (Click here) - -
3 REAR SEAT ADJUSTER BOLT COVER 72329F - - -
4 RECLINING ADJUSTER RELEASE HANDLE RH 72525R - - -
5 REAR NO. 1 SEAT RECLINING COVER RH 71833S (Click here) - -
6 NO. 1 FOLD SEAT STOPPER BAND ASSEMBLY 78950F - - -
7 NO. 1 SEAT NO. 2 CUSHION COVER 79952A - - -
8 NO. 1 SEAT NO. 1 CUSHION COVER 79951B - - -
9 REAR NO. 1 SEAT NO. 4 LEG SIDE COVER 79967W - - -
10 REAR NO. 1 SEAT HINGE SUB-ASSEMBLY LH 71302C - - -
11 REAR NO. 1 SEAT HINGE SUB-ASSEMBLY RH 71301G - - -
12 REAR SEAT CUSHION COVER RH 72995F - - -
13 REAR SEAT CUSHION UNDER COVER RH 72927F - - -
14 REAR CENTER SEAT LAP TYPE BELT ASSEMBLY 73350 - - -
15 REAR NO. 1 SEAT INNER BELT ASSEMBLY RH 73380C - - -
16 REAR CENTER SEAT 3 POINT TYPE BELT ASSEMBLY (SEAT ANCHOR) 73310D - - -
17 REAR SEATBACK COVER 72996H - - -
18 REAR SEATBACK BOARD SUB-ASSEMBLY RH 71701A - - -
19 SEPARATE TYPE REAR SEAT CUSHION ASSEMBLY RH - (Click here) - -
20 REAR NO. 1 SEAT CUSHION PAD RH (OCCUPANT DETECTION SENSOR) 71611H (Click here) - -
21 REAR NO. 1 SEAT CUSHION HEATER ASSEMBLY RH 87510Z (Click here) - -

*A w/ Seat Heater System - -
*1 NO. 1 SEAT CUSHION COVER SUB-ASSEMBLY RH *2 HOG RING
● Non-reusable part - -

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the rear No. 1 seat cushion pad RH (occupant detection sensor) removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedures Effect/Inoperative Function When Necessary Procedures are not Performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point Parking assist monitor system (Click here)
Multi-terrain monitor system (Click here)
Panoramic view monitor system (Click here)

CAUTION:
B543257

·

Wear protective gloves. Sharp areas on the parts may injure your hands.

·

There is risk of injury.



HINT:
·

When the cable is disconnected/reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

-

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Stop and start system Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) (Click here)
Lighting system (EXT) Cornering lights Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 seconds or more. (Click here)
Pre-collision system
Lane tracing assist system
Lane departure alert system
Adaptive high beam system

-

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power back door system Fully close the back door by hand.
HINT:

Initialization is not necessary if the above procedures are performed while the back door is closed.


(Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor and expansion valve standard position is recognized. -


·

Move both front seats to the frontmost position and fold them forward.



PROCEDURE

Hide 71834S 2.REMOVE REAR NO. 1 SEAT RECLINING COVER LH

Z101186

Click here(Click here)

Hide 72525R 4.REMOVE RECLINING ADJUSTER RELEASE HANDLE RH

Hide 71833S 5.REMOVE REAR NO. 1 SEAT RECLINING COVER RH

Z101186

Click here(Click here)

Hide 78950F 6.REMOVE NO. 1 FOLD SEAT STOPPER BAND ASSEMBLY

Hide 79967W 9.REMOVE REAR NO. 1 SEAT NO. 4 LEG SIDE COVER

Hide 71302C 10.REMOVE REAR NO. 1 SEAT HINGE SUB-ASSEMBLY LH

Hide 71301G 11.REMOVE REAR NO. 1 SEAT HINGE SUB-ASSEMBLY RH

Hide 73310D 16.DISCONNECT REAR CENTER SEAT 3 POINT TYPE BELT ASSEMBLY (SEAT ANCHOR)

Hide 71701A 18.REMOVE REAR SEATBACK BOARD SUB-ASSEMBLY RH

Hide 19.REMOVE SEPARATE TYPE REAR SEAT CUSHION ASSEMBLY RH

Z101186

(Click here)

Hide 71611H 20.REMOVE REAR NO. 1 SEAT CUSHION PAD RH (OCCUPANT DETECTION SENSOR)

Z101186

NOTICE:

Be careful not to dirty or damage the No. 1 seat cushion cover sub-assembly RH and the rear No. 1 seat cushion pad RH.



a.
B621722C01
0.177,0.24 0.458,0.594 0.281,0.354 18 false i 3.354,0.292 3.635,0.646 0.281,0.354 18 false ii
V100155

Fastener - -


i.

Remove the 12 hog rings and 2 fasteners.


ii.

Using a thin-bladed screwdriver, detach the claw to remove the No. 1 seat cushion cover sub-assembly LH from the rear No. 1 seat cushion pad LH as shown in the illustration.

HINT:

Tape the thin-bladed screwdriver tip before use.




Hide 87510Z 21.REMOVE REAR NO. 1 SEAT CUSHION HEATER ASSEMBLY RH (w/ Seat Heater System)

Z101186

(Click here)