| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | REAR NO. 1 SEAT ASSEMBLY RH | - | - | - | - |
| 2 | REAR NO. 1 SEAT ASSEMBLY LH | - | - | - | - |
| *A | w/ Seat Heater System | - | - |
| *1 | NO. 1 SEAT CUSHION COVER SUB-ASSEMBLY LH | *2 | HOG RING |
| ● | Non-reusable part | - | - |
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the rear No. 1 seat cushion pad LH (occupant detection sensor) removal/installation are shown below.
Wear protective gloves. Sharp areas on the parts may injure your hands.
There is risk of injury.
When the cable is disconnected/reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
Move both front seats to the frontmost position and fold them forward.
1.REMOVE REAR NO. 1 SEAT ASSEMBLY RH
for 60/40 Split Seat Type:
Click hereVehicle Interior>SEAT>REAR NO. 1 SEAT ASSEMBLY (for 60/40 Split Seat Type RH Side)>REMOVAL
for 40/20/40 Split Seat Type:
Click hereVehicle Interior>SEAT>REAR NO. 1 SEAT ASSEMBLY (for 40/20/40 Split Seat Type RH Side)>REMOVAL
2.REMOVE REAR NO. 1 SEAT ASSEMBLY LH
72329G 4.REMOVE REAR NO. 2 SEAT ADJUSTER BOLT COVER
72526L 5.REMOVE RECLINING ADJUSTER RELEASE HANDLE LH
78950F 7.REMOVE NO. 1 FOLD SEAT STOPPER BAND ASSEMBLY
79952A 8.REMOVE NO. 1 SEAT NO. 2 CUSHION COVER
79951B 9.REMOVE NO. 1 SEAT NO. 1 CUSHION COVER
79967W 10.REMOVE REAR NO. 1 SEAT NO. 4 LEG SIDE COVER
79967X 11.REMOVE REAR NO. 1 SEAT NO. 5 LEG SIDE COVER
Use the same procedure described for the rear No. 1 seat No. 4 leg side cover.
71302G 12.REMOVE REAR NO. 1 SEAT HINGE SUB-ASSEMBLY LH
71301H 13.REMOVE REAR NO. 1 SEAT HINGE SUB-ASSEMBLY RH
72998D 14.REMOVE REAR SEAT CUSHION COVER LH
72928E 15.REMOVE REAR SEAT CUSHION UNDER COVER LH
73390C 16.REMOVE REAR NO. 1 SEAT INNER BELT ASSEMBLY LH
72996H 17.REMOVE REAR SEATBACK COVER
71702D 18.REMOVE REAR SEATBACK BOARD SUB-ASSEMBLY LH
71612G 20.REMOVE REAR NO. 1 SEAT CUSHION PAD LH (OCCUPANT DETECTION SENSOR)
|
|
|
Fastener | - | - |
Remove the 7 hog rings and 2 fasteners.
Using a thin-bladed screwdriver, detach the claw to remove the No. 1 seat cushion cover sub-assembly LH from the rear No. 1 seat cushion pad LH as shown in the illustration.
Tape the thin-bladed screwdriver tip before use.