| *A | w/ Curtain Shield Airbag | - | - |
|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft.*lbf) |
|
N*m (kgf*cm, ft.*lbf) : Specified torque |
| ● | Non-reusable part | - | - |
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
Use the same procedure for the RH and LH sides.
The following procedure is for the LH side.
Move both front seats to the frontmost position and fold them forward.
73200A 1.INSTALL FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY
73220 2.INSTALL FRONT SEAT OUTER BELT ASSEMBLY LH
| *A | w/ Tension Reducer | - | - |
| *a | Unlock | *b | Lock |
| *c | 45° | - | - |
|
Nut |
|
Pretensioner Connector |
|
Tension Reducer Connector |
|
Bolt |
When the inclination of the retractor is 15° or less, check that the belt can be pulled from the retractor. When the inclination of the retractor is over 45°, check that the belt locks.
Do not disassemble the retractor.
Attach the guide.
Install the front seat outer belt assembly LH with the bolt.
Connect the pretensioner connector.
Refer to How to Connect or Disconnect Airbag Connector:
w/ Tension Reducer:
1. Connect the tension reducer connector.
Install the shoulder anchor of the front seat outer belt assembly LH with the nut.
73024 3.INSTALL FRONT SHOULDER BELT ANCHOR PLATE SUB-ASSEMBLY LH
62412 4.INSTALL CENTER PILLAR GARNISH LH
73220 6.INSTALL FRONT SEAT OUTER BELT ASSEMBLY LH (FLOOR ANCHOR)
73233 7.INSTALL OUTER LAP BELT ANCHOR COVER
74620A 8.INSTALL REAR ASSIST GRIP ASSEMBLY
74617F 9.INSTALL ASSIST GRIP PLUG (for Lower Side)
74617C 10.INSTALL ASSIST GRIP PLUG (for Upper Side)
67918D 11.INSTALL REAR DOOR SCUFF PLATE LH
67914B 12.INSTALL FRONT DOOR SCUFF PLATE LH
13.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
for 1GR-FE:
for V35A-FTS:
for F33A-FTV:
14. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE
When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART