| *A | w/ Grille Shutter | *B | except GR SPORT |
| *C | for GR SPORT | - | - |
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the front bumper assembly removal/installation are shown below.
When the front bumper is damaged or deformed due to an accident or contact with other objects, etc., or the bumper installation area on the body is repaired, it is necessary to perform millimeter wave radar sensor adjustment.
Target Adjustment (Triangle Target):
Target Adjustment (Flat Surface Target):
Driving Adjustment:
Click hereADAS / AD>ADVANCED DRIVER ASSISTANCE SYSTEM>MILLIMETER WAVE RADAR SENSOR>DRIVING ADJUSTMENT
When the front bumper is damaged or deformed due to an accident or contact with other objects, etc., or the bumper installation area on the body is repaired, it is necessary to perform ultrasonic sensor detection angle measurement.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING SUPPORT BRAKE SYSTEM>CALIBRATION
1. PRECAUTION
|
|
2. CHANGE RADIATOR SHUTTER CONTROL STATE (w/ Grille Shutter)
53292A 3.REMOVE UPPER RADIATOR SUPPORT SEAL
75602A 4.REMOVE FRONT FENDER MOULDING SUB-ASSEMBLY LH
|
Clip |
|
Screw |
Remove the front fender moulding sub-assembly LH.
1. Put protective tape around the front fender moulding sub-assembly LH.
2. Using a 4 mm hexagon socket wrench, remove the screw.
3. Remove the 2 clips.
4. Insert a screwdriver with its tip wrapped with protective tape into the gap and detach the claw.
5. Using moulding remover B, detach the clip and disconnect the front fender moulding sub-assembly LH.
Detach the clip one by one.
75601A 5.REMOVE FRONT FENDER MOULDING SUB-ASSEMBLY RH
Use the same procedure described for LH side.
51044 6.REMOVE ENGINE SIDE COVER SUB-ASSEMBLY LH
except GR SPORT:
|
Bolt |
|
Screw |
for GR SPORT:
Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>FRONT BUMPER (for Standard)>REMOVAL
51043 7.REMOVE ENGINE SIDE COVER SUB-ASSEMBLY RH
Use the same procedure described for LH side.
8.REMOVE FRONT BUMPER ASSEMBLY
|
Bolt |
|
Clip |
Put protective tape around the front bumper assembly.
Remove the 2 clips.
Remove the 3 bolts.
except GR SPORT:
|
Bolt |
|
Screw |
Remove the 4 bolts and 4 screws and detach the clip.
for GR SPORT:
|
Bolt |
|
Screw |
Remove the 4 bolts and 2 screws and detach the clip.
| *A | w/ Panoramic View Monitor System | *B | w/ Grille Shutter |
| *C | w/ Headlight Cleaner System | - | - |
|
Connector |
|
Headlight Cleaner Hose |
Disconnect each connector.
w/ Headlight Cleaner System:
1. Detach the claw and disconnect the headlight cleaner hose.
|
Place Hand Here |
|
Remove in this Direction (1) |
|
Remove in this Direction (2) | - | - |
Place your hand at the position shown in the illustration and pull in the direction of the arrow to detach the claws in the order shown in the illustration.
Place your hand at the position shown in the illustration and lift up in the direction of the arrow to detach the claw.
Use the same procedure for the other side.
|
Remove in this Direction | - | - |
Detach the guide and claw and remove the front bumper assembly as shown in the illustration.