| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Note |
|---|---|---|---|---|---|
| P060647 | Control Module Processor Watchdog/Safety MCU Failure | ECM internal error continues for 1 second. (1 trip detection logic) |
ECM | Comes on | SAE Code: P0606 |
| P060747 | Control Module Performance Bank 1 Watchdog/Safety MCU Failure | ECM monitor IC malfunction. (1 trip detection logic) |
ECM | Comes on | SAE Code: P0607 |
| P060787 | Control Module Performance Bank 1 Missing Message | ECM monitor IC malfunction. (1 trip detection logic) |
ECM | Comes on | SAE Code: P0607 |
| P060D49 | Internal Control Module Accelerator Pedal Position Performance Internal Electronic Failure | Either of the following conditions is met:
·
There is an ECM main CPU error.
·
There is an ECM sub CPU error. (1 trip detection logic) |
ECM | Comes on | SAE Code: P060D |
| P160700 | Cruise Control Input Processor | ECM internal error continues for 1 second. (1 trip detection logic) |
ECM | Comes on | SAE Code: P1607 |
| DTC No. | DTC Detection Drive Pattern |
|---|---|
| P060647 P060747 P060787 P060D49 P160700 |
Ignition switch ON for 1 second or more |
After replacing the ECM, the new ECM needs registration (Click here Engine / Hybrid System>F33A-FTV (ENGINE CONTROL)>ECD SYSTEM (w/ DPF)>REGISTRATION) and initialization (Click here Engine / Hybrid System>F33A-FTV (ENGINE CONTROL)>ECD SYSTEM (w/ DPF)>INITIALIZATION).
After replacing the ECM and performing "LEARNING VALUES WRITE", select "PM Regenerate Mode" using Utility of the GTS to perform PM forced regeneration.
Click hereEngine / Hybrid System>F33A-FTV (EMISSION CONTROL)>EMISSION CONTROL SYSTEM>ON-VEHICLE INSPECTION
Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.
Connect the GTS to the DLC3.
Turn the ignition switch to ON and turn the GTS on.
Clear the DTCs.
Turn the ignition switch off and wait for 30 seconds or more.
Turn the ignition switch to ON and wait for 1 second or more.
Enter the following menus: Powertrain / Engine / Trouble Codes.
Read the DTCs.
| Result | Proceed to |
|---|---|
| DTC P060647, P060747, P060787, P060D49 and/or P160700 is output | A |
| No DTC is output | B |
A
B
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
Replace the ECM.
Click hereEngine / Hybrid System>F33A-FTV (ENGINE CONTROL)>ECM>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT
Clear the DTCs.
Turn the ignition switch off and wait for 30 seconds or more.
Turn the ignition switch to ON and wait for 1 second or more.
Enter the following menus: Powertrain / Engine / Trouble Codes.
Confirm that the DTC is not output again.
| Proceed to |
|---|
| NEXT |
NEXT