| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | STABILIZER CONTROL WITH ACCUMULATOR HOUSING ASSEMBLY | 48860D | ( ) |
- | - |
| 2 | REAR STABILIZER CONTROL TUBE ASSEMBLY | - | ( ) |
- | - |
|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft.*lbf) |
|
N*m (kgf*cm, ft.*lbf): Specified torque |
| * | For use with a union nut wrench | - | - |
48860D 1.INSTALL STABILIZER CONTROL WITH ACCUMULATOR HOUSING ASSEMBLY
|
|
2.CONNECT REAR STABILIZER CONTROL TUBE ASSEMBLY
| *a | Torque Wrench Fulcrum Length | - | - |
Using a union nut wrench, connect the rear stabilizer control tube assembly.
Do not kink or damage the rear stabilizer control tube assembly.
Do not allow any foreign matter such as dirt or dust to enter the rear stabilizer control tube assembly from the connecting parts.
Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
for Specified Tightening Torque (A):
When using a union nut wrench (fulcrum length of 30 mm (1.181 in.)) + torque wrench (fulcrum length of 180 mm (7.087 in.)):
37.8 N*m (385 kgf*cm, 28 ft.*lbf)
for Specified Tightening Torque (B):
When using a union nut wrench (fulcrum length of 22 mm (0.866 in.)) + torque wrench (fulcrum length of 162 mm (6.38 in.)):
13.4 N*m (137 kgf*cm, 10 ft.*lbf)
3.INSTALL STEP SUB-ASSEMBLY LH
4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
for V35A-FTS:
for F33A-FTV:
6.APPLY PRESSURE ACCORDING TO TEMPERATURE MANAGEMENT CHART WHEN FILLING FLUID
9. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE
When disconnecting and reconnecting the battery , there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART