| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | FLOOR SHIFT LEVER ASSEMBLY | - | - | - | - |
| 2 | DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY | 33820B | ( ) |
- | - |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 3 | FRAME UNDER COVER ASSEMBLY RH | 51430A | - | - | - |
| 4 | TRANSMISSION CONTROL CABLE INSULATOR | 33825 | - | - | - |
| 5 | REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY | 33820B | ( ) |
- | - |
| *A | for V35A-FTS | *B | for F33A-FTV |
| ● | Non-reusable part | - | - |
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1.REMOVE FLOOR SHIFT LEVER ASSEMBLY
33820B 2.DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY
|
Push In | - | - |
Detach the clamp and disconnect the wire harness connector holder.
Detach the grommet from the vehicle body.
Push in the grommet to the floor hole and disconnect the transmission control cable assembly from the vehicle body.
Do not twist the transmission control cable assembly too much.
51430A 3.REMOVE FRAME UNDER COVER ASSEMBLY RH
33825 4.REMOVE TRANSMISSION CONTROL CABLE INSULATOR
| *A | for V35A-FTS | *B | for F33A-FTV |
33820B 5.REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY
| *a | Clip | *b | 45° to 60° |
|
Remove in this Direction | - | - |
Remove the clip from the No. 1 transmission control cable bracket.
While disengaging the clip as shown in the illustration, disconnect the transmission control cable assembly from the transmission control shaft lever RH together with the clip.