| *1 | OIL COOLER TUBE SUB-ASSEMBLY | - | - |
|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft.*lbf) |
|
N*m (kgf*cm, ft.*lbf): Specified torque |
27060 1.INSTALL GENERATOR ASSEMBLY
| *a | Stopper | - | - |
Using an E8 "TORX" socket wrench, temporarily install the generator assembly with the 2 stud bolts.
Install the generator assembly with the 2 bolts and 2 nuts.
Connect the oil cooler tube sub-assembly to the generator assembly with the bolt.
Check that the stopper is secure.
16603B 2.INSTALL IDLER PULLEY SUB-ASSEMBLY
82121 3.INSTALL ENGINE WIRE
4.INSTALL RADIATOR WITH COOLER CONDENSER ASSEMBLY
5.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
6. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE
When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART