| *1 | NO. 2 AIR HOSE | *2 | ENGINE OIL LEVEL DIPSTICK |
| *3 | GAS FILTER BRACKET | *4 | STARTER HOSE BRACKET SUB-ASSEMBLY |
| *5 | HOSE CLAMP | - | - |
| ● | Non-reusable part | - | - |
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the intercooler assembly removal/installation are shown below.
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
1. PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
3.DRAIN COOLANT (for Intercooler)
26100G 4.REMOVE DIESEL THROTTLE BODY ASSEMBLY
12142 5.REMOVE NO. 2 ENGINE OIL LEVEL DIPSTICK GUIDE
23100Y 6.REMOVE FUEL PRIMING PUMP ASSEMBLY
16515A 7.REMOVE NO. 1 INTERCOOLER COOLING WATER PIPE
51478C 8.REMOVE UPPER ENGINE SIDE UNDER COVER PLATE LH
51470C 9.REMOVE REAR ENGINE SIDE UNDER COVER ASSEMBLY LH
51448M 10.REMOVE ENGINE SIDE UNDER COVER RH
44360 11.DISCONNECT VANE PUMP OIL RESERVOIR ASSEMBLY
82121 12.DISCONNECT ENGINE WIRE
for RHD:
| *A | for Upper Side | *B | for Front Side |
| *C | for RH Side | *D | for LH Side |
| *E | for Cold Area Specification Vehicles | - | - |
for LHD:
| *A | for Upper Side | *B | for Front Side |
| *C | for RH Side | *D | for LH Side |
| *E | for Cold Area Specification Vehicles | *F | w/ Stop and Start System |
12631A 13.REMOVE ENGINE COVER BRACKET
82712K 14.REMOVE WIRING HARNESS SUPPORT
17940D 15.REMOVE INTERCOOLER ASSEMBLY