| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY | 55708 | - | - | - |
| 2 | UPPER ENGINE SIDE UNDER COVER PLATE LH | 51478C | - | - | - |
| 3 | REAR ENGINE SIDE UNDER COVER ASSEMBLY LH | 51470C | - | - | - |
| 4 | ENGINE SIDE UNDER COVER RH | 51448M | - | - | - |
| 5 | REAR ENGINE SIDE UNDER COVER ASSEMBLY RH | 51460C | - | - | - |
| 6 | NO. 1 HEATER COVER | 87114E | - | - | - |
| 7 | DASH PANEL INSULATOR OUTER | 55223A | - | - | - |
| *1 | Outlet Heater Water Hose A | - | - |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 8 | NO. 1 ENGINE COVER SUB-ASSEMBLY | 12601B | - | - | - |
| 9 | INTAKE PIPE OR HOSE STAY | 17138 | - | - | - |
| 10 | NO. 1 INTAKE PIPE | 17113E | - | - | - |
| 11 | DIESEL THROTTLE BODY ASSEMBLY | 26100G | ( ) |
- | - |
| *1 | Vacuum Hose | ● | Non-reusable part |
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the diesel throttle body assembly removal/installation are shown below.
55708 1.REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY
51478C 2.REMOVE UPPER ENGINE SIDE UNDER COVER PLATE LH
51470C 3.REMOVE REAR ENGINE SIDE UNDER COVER ASSEMBLY LH
51448M 4.REMOVE ENGINE SIDE UNDER COVER RH
51460C 5.REMOVE REAR ENGINE SIDE UNDER COVER ASSEMBLY RH
87114E 6.REMOVE NO. 1 HEATER COVER
55223A 7.REMOVE OUTER DASH PANEL INSULATOR
12601B 8.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY
17138 9.DISCONNECT INTAKE PIPE OR HOSE STAY
Remove the bolt and intake pipe or hose stay from the diesel throttle body assembly.
17113E 10.DISCONNECT NO. 1 INTAKE PIPE
Slide the hose clip and disconnect the vacuum hose.
Remove the 7 bolts and disconnect the No. 1 intake pipe from the diesel throttle body assembly.
26100G 11.REMOVE DIESEL THROTTLE BODY ASSEMBLY
| *a | Push toward rear | *b | Close throttle valve |
| *c | Throttle valve | - | - |
Push the No. 1 intake pipe toward the rear to secure space.
Remove the diesel throttle body assembly with the throttle valve closed.
Remove the gaskets.