| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | AIR FUEL RATIO SENSOR | 89467B | ( ) |
- | - |
| 2 | FRONT EXHAUST PIPE SUB-ASSEMBLY | 17401 | - | - | - |
| 3 | PERFORM INITIALIZATION | - | - | - | ( ) |
|
N*m (kgf*cm, ft.*lbf): Specified torque | * | For use with SST |
89467B 1.INSTALL AIR FUEL RATIO SENSOR
Do not reuse the sensor which has been dropped or taken on a strong impact.
Do not pull and twist the sensor wire strongly.
Confirm the glass tube color (green) and recognition tape color (white) to prevent the wrong sensor installation.
Securely connect the connector until it locks.
| *a | Torque Wrench Fulcrum Length | - | - |
Tighten the air fuel ratio sensor.
Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.
When using SST (fulcrum length of 30 mm (1.181 in.)) + torque wrench (fulcrum length of 255 mm (10.039 in.)): 39.4 N*m (402 kgf*cm, 29 ft.*lbf)
17401 2.INSTALL FRONT EXHAUST PIPE SUB-ASSEMBLY
3.PERFORM INITIALIZATION
Perform "Clear A/F sensor Compensation data" after replacing the air fuel ratio sensor.
Click hereEngine / Hybrid System>F33A-FTV (ENGINE CONTROL)>ECD SYSTEM (w/ DPF)>INITIALIZATION