Home › Engine / Hybrid System › F33A-FTV (ENGINE CONTROL) › ECD SYSTEM (w/o DPF) › from 2021.07
RM38G0E _51 Engine / Hybrid System _106329 F33A-FTV ENGINE CONTROL _0484891 ECD SYSTEM(w/o DPF) C

F33A-FTV ENGINE CONTROL  ECD SYSTEM(w/o DPF)  P245A18  Exhaust Gas Recirculation Cooler Bypass Control Circuit Low Bank 1 Circuit Current Below Threshold  P245A19  Exhaust Gas Recirculation Cooler Bypass Control Circuit High Bank 1 Circuit Current Above Threshold  


DESCRIPTION

The DC motor type No. 2 EGR valve assembly (EGR cooler bypass valve) consecutively changes the position of the EGR cooler route and bypass route, and sets an arbitrary EGR temperature.

The actual EGR gas temperature is measured by the EGR gas temperature sensor, and the position of the No. 2 EGR valve assembly (EGR cooler bypass valve) is fed back by the position sensor.

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Note
P245A18 Exhaust Gas Recirculation Cooler Bypass Control Circuit Low Bank 1 Circuit Current Below Threshold Both of the following conditions are met for 2.0 seconds:
·

The EGR cooler bypass control valve actuator duty cycle is 80% or higher.

·

The EGR cooler bypass control valve actuator current is less than 0.5 A.


(1 trip detection logic)
·

Open or short in EGR cooler bypass control valve actuator circuit

·

No. 2 EGR valve assembly (EGR cooler bypass valve)

·

ECM


Comes on SAE Code: P245C
P245A19 Exhaust Gas Recirculation Cooler Bypass Control Circuit High Bank 1 Circuit Current Above Threshold Either of the following conditions is met for 2.0 seconds:
·

EGR cooler bypass control valve actuator current of 8 A or higher is detected.

·

The ECM internal circuit temperature of 150°C (302°F) or higher is detected.


(1 trip detection logic)
·

Open or short in EGR cooler bypass control valve actuator circuit

·

No. 2 EGR valve assembly (EGR cooler bypass valve)

·

ECM


Comes on SAE Code: P245D

Related Data List
DTC No. Data List
P245A18
P245A19
·

EGR Cooler Bypass Valve Duty Ratio

·

EGR Cooler Bypass Valve Motor Current



CONFIRMATION DRIVING PATTERN

DTC No. DTC Detection Drive Pattern
P048718
P048719
Bypass and Cooler are held for 5 seconds or more when the Active Test "Activate the EGR Cooler Bypass Control Valve" is performed.

CAUTION / NOTICE / HINT

NOTICE:

After replacing the ECM, the new ECM needs registration (Click hereEngine / Hybrid System>F33A-FTV (ENGINE CONTROL)>ECD SYSTEM (w/o DPF)>REGISTRATION) and initialization (Click hereEngine / Hybrid System>F33A-FTV (ENGINE CONTROL)>ECD SYSTEM (w/o DPF)>INITIALIZATION).


HINT:

Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.


PROCEDURE

1.INSPECT NO. 2 EGR VALVE ASSEMBLY (EGR COOLER BYPASS VALVE)
a.

Remove the No. 2 EGR valve assembly (EGR cooler bypass valve).


b.
A494771C01
0.292,0.406 0.604,0.563 0.313,0.156 10 false *a
*a Component without harness connected
(No. 2 EGR Control Valve Assembly (EGR cooler bypass valve))


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
5 - 6 Always No short or no open circuit



Result:
Proceed to
OK
NG



OK

2.CHECK HARNESS AND CONNECTOR (NO. 2 EGR VALVE ASSEMBLY (EGR COOLER BYPASS VALVE) - ECM)

NG

6.REPLACE NO. 2 EGR VALVE ASSEMBLY (EGR COOLER BYPASS VALVE)
2.CHECK HARNESS AND CONNECTOR (NO. 2 EGR VALVE ASSEMBLY (EGR COOLER BYPASS VALVE) - ECM)
a.

Disconnect the No. 2 EGR valve assembly (EGR cooler bypass valve) connector.


b.

Disconnect the ECM connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition

Click Location & Routing(C130,C138)Location & Routing

Click Connector(C130)Engine Compartment>Connecting Wire / Cooling Fan Wire / Engine Wire / Fuel Pump Motor Wire / No. 1 Connecting Wire / No. 10 Engine Wire / No. 2 Connecting Wire / No. 3 Connecting Wire / No. 4 Connecting Wire / Sensor Wire / Turbocharger Wire>No. 2 EGR Valve Assembly

Click Connector(C138)Engine Compartment>Connecting Wire / Cooling Fan Wire / Engine Wire / Fuel Pump Motor Wire / No. 1 Connecting Wire / No. 10 Engine Wire / No. 2 Connecting Wire / No. 3 Connecting Wire / No. 4 Connecting Wire / Sensor Wire / Turbocharger Wire>ECM

C130-6 (ECM+) - C138-4 (ECM+) Always Below 1 Ω
C130-5 (ECM-) - C138-23 (ECM-) Always Below 1 Ω
C130-6 (ECM+) or C138-4 (ECM+) - Body ground and other terminals Always 10 kΩ or higher
C130-5 (ECM-) or C138-23 (ECM-) - Body ground and other terminals Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

3.REPLACE ECM

NG

4.REPAIR OR REPLACE HARNESS OR CONNECTOR
3.REPLACE ECM

Result:
Proceed to
NEXT



NEXT

5.CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED
4.REPAIR OR REPLACE HARNESS OR CONNECTOR
a.

Repair or replace the harness or connector.


Result:
Proceed to
NEXT



NEXT

5.CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED
5.CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED
a.

Clear the DTCs.

Powertrain > Engine > Clear DTCs
50002 372

b.

Turn the ignition switch off and wait for 30 seconds.


c.

Bypass and Cooler are held for 5 seconds or more when the Active Test "Activate the EGR Cooler Bypass Control Valve" is performed.

Powertrain > Engine > Active Test
Tester Display
Activate the EGR Cooler Bypass Control Valve
50004 372 42025

d.

Enter the following menus: Powertrain / Engine / Trouble Codes.

Powertrain > Engine > Trouble Codes
50001 372

e.

Confirm that the DTC is not output.


Result:
Proceed to
NEXT



NEXT

END

6.REPLACE NO. 2 EGR VALVE ASSEMBLY (EGR COOLER BYPASS VALVE)
a.

Replace the No. 2 EGR valve assembly (EGR cooler bypass valve).

Click hereEngine / Hybrid System>F33A-FTV (EMISSION CONTROL)>EGR VALVE>REMOVAL


Result:
Proceed to
NEXT



NEXT

5.CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED