The Malfunction Indicator Lamp (MIL) is used to indicate vehicle malfunctions detected by the ECM.
The MIL operation can be checked visually. When the ignition switch is first turned to ON, the MIL should be illuminated and should then turn off after the engine is started. If the MIL remains illuminated or is not illuminated, conduct the following troubleshooting procedure using the GTS.
Check the illumination condition of the MIL.
| MIL | Condition | Proceed to |
|---|---|---|
| Illuminates → Turns off | Ignition switch ON → engine is started | A |
| Other than above | - | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
Connect the GTS to the DLC3.
Turn the ignition switch to ON and turn the GTS on.
Check the communication between the GTS and ECM.
It can be checked using the "Engine" item of the Data List.
| Result | Proceed to |
|---|---|
| Communication is possible | A |
| Communication is not possible | B |
A
B
Connect the GTS to the DLC3.
Turn the ignition switch to ON and turn the GTS on.
Enter the following menus: System Select / Health Check.
Check if any DTCs have been detected. Note down any DTCs.
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| Any DTCs is output | B |
Check for detected DTCs output from other ECUs which relate to the MIL.
A
B
Check the status of the MIL while performing the Active Test.
| Tester Display |
|---|
| Check Engine Warning |
| Result | Proceed to |
|---|---|
| Changes | A |
| Does not change | B |
A
B