| *1 | HEADLIGHT HOUSING LH | *2 | BASE B ASSEMBLY |
| ● | Non-reusable part | - | - |
|
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
| ● | Non-reusable part | - | - |
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
85967D 1.INSTALL LIGHT CONTROL LED ECU LH
|
|
|
Install in this Direction | - | - |
|
Connector |
|
Screw |
Attach the connector and install the light control LED ECU LH with the 2 screws.
Push the base b assembly in the direction shown in the illustration.
Connect the 3 connectors.
Attach the clamp and install the 3 screws.
81144 5.INSTALL NO. 1 HEADLIGHT COVER
81134 6.INSTALL HEADLIGHT GASKET
81056A 7.INSTALL HEADLIGHT ECU SUB-ASSEMBLY LH
8.INSTALL HEADLIGHT CORD LH
9.INSTALL HEADLIGHT BRACKET LH
10.INSTALL HEADLIGHT ASSEMBLY LH
11.PERFORM SYSTEM INITIALIZATION
12.ADJUST HEADLIGHT AIMING