11381A 1.INSTALL REAR CRANKSHAFT OIL SEAL
Apply engine oil to the lip of a new rear crankshaft oil seal.
Using SST and a hammer, tap in the rear crankshaft oil seal as shown in the illustration.
2.7 to 3.7 mm (0.106 to 0.146 in.)
Keep the lip free from foreign matter.
Do not tap on the rear crankshaft oil seal at an angle.
Make sure that the lip of the rear crankshaft oil seal is properly installed.
13405 2.INSTALL FLYWHEEL SUB-ASSEMBLY
31250 3.INSTALL CLUTCH DISC ASSEMBLY
31210 4.INSTALL CLUTCH COVER ASSEMBLY
5.INSTALL MANUAL TRANSMISSION WITH TRANSFER