1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
51442 3.REMOVE NO. 2 ENGINE UNDER COVER
4.DRAIN ENGINE COOLANT
16571C 5.REMOVE NO. 1 RADIATOR HOSE
16572D 6.REMOVE NO. 2 RADIATOR HOSE
16711 7.REMOVE FAN SHROUD
8.REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE
16323 9.REMOVE WATER INLET HOUSING
| *1 | Oil Cooler Hose |
| *2 | No. 2 Oil Cooler Hose |
Slide the 2 clips and disconnect the oil cooler hose and No. 2 oil cooler hose from the water inlet housing.
| *1 | Water By-pass Hose |
| *2 | No. 2 Water By-pass Hose |
| *3 | No. 3 Water By-pass Hose |
| *4 | No. 4 Water By-pass Hose |
| *5 | No. 5 Water By-pass Hose |
Slide the 2 clips and disconnect the No. 4 water by-pass hose and No. 5 water by-pass hose from the water inlet housing.
Slide the clip and disconnect the No. 2 water by-pass hose from the water inlet housing.
Slide the 2 clips and disconnect the water by-pass hose from the water inlet housing and union.
Slide the clip and disconnect the No. 3 water by-pass hose from the water inlet housing.
Remove the 5 bolts and water inlet housing.
Remove the gasket from the No. 1 water outlet pipe.
Remove the gasket from the engine water pump assembly.
16604 10.REMOVE NO. 2 IDLER PULLEY SUB-ASSEMBLY
27020 11.REMOVE GENERATOR ASSEMBLY
16620 12.REMOVE V-RIBBED BELT TENSIONER ASSEMBLY
16631B 13.REMOVE IDLER PULLEY BRACKET (w/o Air Conditioning System)
Remove the 3 bolts and idler pulley assembly.
88320 14.DISCONNECT COOLER COMPRESSOR ASSEMBLY (w/ Air Conditioning System)
16100 15.REMOVE ENGINE WATER PUMP ASSEMBLY
Remove the 17 bolts, engine water pump assembly and gasket.