Home › Drivetrain › H150F (MANUAL TRANSMISSION / TRANSAXLE) › TRANSMISSION CASE OIL SEAL
RM25T0E _52 Drivetrain _029902 H150F MANUAL TRANSMISSION / TRANSAXLE _0137684 TRANSMISSION CASE OIL SEAL A

H150F MANUAL TRANSMISSION / TRANSAXLE  TRANSMISSION CASE OIL SEAL  REPLACEMENT  


PROCEDURE

Hide 33131 2.REMOVE FRONT BEARING RETAINER

C171381

a.

Remove the 8 bolts.


b.

Using a brass bar and hammer, tap off the front bearing retainer from the manual transmission case.


Hide 33131A 3.REMOVE FRONT TRANSMISSION BEARING RETAINER OIL SEAL

a.
C171295C01
0.625,0.302 1.198,0.302 1.198,0.302 1.625,0.677 true 0.365,0.229 0.677,0.427 0.313,0.198 10 false *a
*a Protective Tape


Using a screwdriver, pry out the front transmission bearing retainer oil seal.

NOTICE:

Be careful not to damage the lip of the front transmission bearing retainer oil seal and front bearing contact surfaces.


HINT:

Tape the screwdriver tip before use.


NOTICE:
·

Protect the front bearing retainer with a cloth to prevent it from being damaged

·

Be careful not to damage the lip of the front transmission bearing retainer oil seal and front bearing contact surfaces.




Hide 33131A 4.INSTALL FRONT TRANSMISSION BEARING RETAINER OIL SEAL

a.
C171296

Using SST and a press, drive in a new front transmission bearing retainer oil seal.

SST
09950-60010  (09951-00460)
09950-70010  (09951-07150)

Standard Drive in Depth:

15.4 to 16.2 mm (0.6063 to 0.6377 in.)


NOTICE:

Install the front transmission bearing retainer oil seal in the correct direction.



b.

Apply MP grease to the lip of the front transmission bearing retainer oil seal.


Hide 33131 5.INSTALL FRONT BEARING RETAINER

a.

Remove any seal packing from the contact surfaces of the front bearing retainer and transmission case and clean the surfaces with a non-residue solvent.


b.

Clean the 8 bolts and installation holes with a non-residue solvent.


c.
C171194C01
0.698,1.292 0.969,1.292 0.969,1.292 1.208,1.031 true 0.51,1.229 0.823,1.427 0.313,0.198 10 false *a
*a Seal Packing


Apply seal packing to the front bearing retainer, as shown in the illustration.

Seal Packing:

Toyota Genuine Seal Packing 1281, Three Bond 1281 or equivalent


NOTICE:
·

Install the front bearing retainer within 10 minutes of application.

·

Make sure that foreign matter or oil does not adhere to the application surface.

·

Apply seal packing in the middle along the seal surface and inner side around the bolt holes.

·

Overlap the seal packing application start and end positions by 1 to 5 mm.




d.

Using a plastic-faced hammer, lightly tap the front bearing retainer so that it fully contacts the transmission case.


e.

Apply adhesive to 2 or 3 threads of the bolts.

Adhesive:

Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent



f.
C171381

Install the front bearing retainer to the transmission case with the 8 bolts.

Torque:
16.66 N*m (170 kgf*cm, 12 ft.*lbf)

NOTICE:

Uniformly tighten the bolts in several steps