Home › Drivetrain › H150F (MANUAL TRANSMISSION / TRANSAXLE) › MANUAL TRANSMISSION ASSEMBLY (for 1GR-FE) › 2014.08–2022.09
RM25T0E _52 Drivetrain _029902 H150F MANUAL TRANSMISSION / TRANSAXLE _0137560 MANUAL TRANSMISSION ASSEMBLY(for 1GR-FE) A

H150F MANUAL TRANSMISSION / TRANSAXLE  MANUAL TRANSMISSION ASSEMBLY(for 1GR-FE)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

CAUTION:

Be sure to read precaution thoroughly before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION


NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


Hide 51442 3.REMOVE NO. 2 ENGINE UNDER COVER

Hide 16571C 5.REMOVE NO. 1 RADIATOR HOSE

Hide 16711 6.REMOVE FAN SHROUD

Hide 17705 7.REMOVE AIR CLEANER CAP SUB-ASSEMBLY WITH NO. 1 AIR CLEANER HOSE

Hide 67913 9.REMOVE FRONT DOOR SCUFF PLATE RH

HINT:

Use the same procedure described for the LH side.


Hide 62111A 11.REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH

HINT:

Use the same procedure described for the LH side.


Hide 89170 15.REMOVE AIRBAG SENSOR ASSEMBLY WITH AIRBAG SENSOR BRACKET (w/ Airbag System)

Hide 89441A 16.REMOVE DECELERATION SENSOR (w/ ABS)

Hide 36303 17.REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY

Hide 58286 18.REMOVE NO. 1 SHIFT AND SELECT LEVER BOOT

Hide 33530F 19.REMOVE TRANSMISSION SHIFT LEVER ASSEMBLY

C313778C01
1.333,0.635 1.5,0.219 1.5,0.219 1.75,0.219 true 1.875,0.135 2.188,0.333 0.313,0.198 10 false *a
*a Cloth or Equivalent
V100135

Down
V100136

Counterclockwise


a.

Cover the shift lever cap with a cloth or equivalent.


b.

While pressing down on the shift lever cap, turn it counterclockwise to remove the transmission shift lever assembly.


c.

Pull out the transmission shift lever assembly.


Hide 20.REMOVE TRANSFER SHIFT LEVER ASSEMBLY

Hide 36308 21.DISCONNECT HIGH AND LOW SHIFT ROD SUB-ASSEMBLY

a.

Remove the nut and washer, disconnect the high and low shift rod sub-assembly.


Hide 22.DRAIN MANUAL TRANSMISSION OIL

a.

Remove the drain plug sub-assembly and gasket, and then drain the manual transmission oil.


b.

Install a new gasket and the drain plug sub-assembly.

Torque:
37.24 N*m (380 kgf*cm, 27 ft.*lbf)


Hide 51447C 23.REMOVE TRANSFER CASE PROTECTOR

C213828

a.

Remove the 3 bolts and transfer case protector from the No. 2 frame crossmember sub-assembly.


Hide 17410 24.REMOVE FRONT EXHAUST PIPE ASSEMBLY (for Model Code #J78, #J79 Series)

Hide 17410 25.REMOVE FRONT EXHAUST PIPE ASSEMBLY (for Model Code #J71, #J76 Series)

Hide 17118 26.REMOVE NO. 1 EXHAUST MANIFOLD STAY

Hide 37140 28.REMOVE FRONT PROPELLER SHAFT ASSEMBLY

Hide 37110 29.REMOVE REAR PROPELLER SHAFT ASSEMBLY

Hide 28100 30.REMOVE STARTER ASSEMBLY

Hide 31121 31.REMOVE NO. 1 CLUTCH HOUSING COVER

Hide 31470 32.DISCONNECT CLUTCH RELEASE CYLINDER ASSEMBLY

C213829

a.

Remove the 4 bolts and disconnect the clutch release cylinder assembly.


Hide 33.REMOVE FRONT STABILIZER BRACKET LH

C161532

a.

Remove the 2 bolts and front stabilizer bracket LH.


Hide 34.REMOVE FRONT STABILIZER BRACKET RH

HINT:

Use the same procedures described for the LH side.


Hide 35.SUPPORT MANUAL TRANSMISSION

C160886

a.

Support the manual transmission with a transmission jack.


Hide 51203 36.REMOVE NO. 2 FRAME CROSSMEMBER SUB-ASSEMBLY

a.
C312481C01
0,0 0,0 false
V100135

Nut
V100136

Bolt


Remove the 8 bolts.


b.

Remove the 2 nuts and No. 2 frame crossmember sub-assembly.


Hide 12371 37.REMOVE REAR ENGINE MOUNTING INSULATOR

C161536

a.

Remove the 4 bolts and rear engine mounting insulator from the manual transmission with transfer.


Hide 38.DISCONNECT WIRE HARNESS

a.
C213830

Remove the bolt and disconnect the No. 2 cable bond.


b.
C312650

Remove the clamp and disconnect the wire harness from the manual transmission.


c.

Tilt the manual transmission together with the transfer downward.


d.
C312355

Support the engine assembly with the jack and engine lifter so that it is stable as shown in the illustration.


e.

Disconnect the connectors and clamps, and then disconnect the wire harness from the manual transmission.


Hide 39.REMOVE MANUAL TRANSMISSION WITH TRANSFER

C213823

a.

Remove the 9 bolts and manual transmission with transfer.

NOTICE:

Do not use excess force to pry off the transmission.



Hide 36112B 40.REMOVE REAR NO. 1 TRANSFER CASE HOSE

C312891

a.

Disconnect the clamp.


b.

Slide the clip and disconnect the rear No. 1 transfer case hose from the manual transmission.


Hide 41.REMOVE TRANSFER ASSEMBLY

C161482

a.

Remove the 6 bolts and transfer assembly from the manual transmission.


Hide 42.REMOVE WIRE HARNESS CLAMP BRACKET

a.
C312649

Remove the 2 bolts and 2 wire harness clamp brackets.


b.
C312645

Remove the bolt and air fuel ratio sensor bracket LH.


c.
C312646

Remove the bolt and air fuel ratio sensor bracket RH.


d.
C312647

Remove the bolt and heated oxygen sensor bracket LH.


e.
C312648

Remove the bolt and heated oxygen sensor bracket RH.


Hide 31204 43.REMOVE CLUTCH RELEASE FORK SUB-ASSEMBLY

Hide 31237 44.REMOVE CLUTCH RELEASE FORK SUPPORT BOOT

Hide 31236B 45.REMOVE RELEASE FORK SUPPORT