1.REMOVE FRONT SEAT
for Separate Seat Type:
Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Separate Seat Type)>REMOVAL
for Bench Seat Type:
Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Bench Seat Type)>REMOVAL
55480D 2.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY
77306 3.REMOVE FUEL LID LOCK OPEN LEVER SUB-ASSEMBLY
Detach the 3 claws.
Disconnect the fuel lid lock control cable sub-assembly from the fuel lid lock open lever sub-assembly.
67914 4.REMOVE FRONT DOOR SCUFF PLATE LH
for Model Code #J76 Series:
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (for Semi-long Body)>REMOVAL
for Model Code #J71 Series:
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (for Short Body)>REMOVAL
67913 5.REMOVE FRONT DOOR SCUFF PLATE RH
Use the same procedure described for the LH side.
58191 6.REMOVE FRONT FLOOR FOOTREST
62112A 7.REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH
73297B 8.REMOVE QUARTER TRIM BELT HOLE COVER RH (for Model Code #J71 Series)
Remove the 2 screws and quarter trim belt hole cover.
73298 9.REMOVE NO. 2 QUARTER TRIM BELT HOLE COVER RH (for Model Code #J71 Series)
Remove the 2 screws and No. 2 quarter trim belt hole cover.
67918A 10.REMOVE REAR DOOR SCUFF PLATE LH (for Model Code #J76 Series)
67917A 11.REMOVE REAR DOOR SCUFF PLATE RH (for Model Code #J76 Series)
Use the same procedure described for the LH side.
62414A 12.REMOVE LOWER CENTER PILLAR GARNISH LH (for Model Code #J76 Series)
62413A 13.REMOVE LOWER CENTER PILLAR GARNISH RH (for Model Code #J76 Series)
62551F 14.REMOVE REAR SEAT SIDE GARNISH RH (for Model Code #J76 Series)
Detach the 2 clips.
Slide the garnish in the direction of the arrow shown in the illustration to remove the rear seat side garnish.
62511 15.REMOVE QUARTER INSIDE TRIM BOARD RH
for Model Code #J76 Series:
Detach the 12 clips and remove the panel.
for Model Code #J71 Series:
Detach the 13 clips and remove the panel.
57627C 16.REMOVE REAR FLOOR SIDE MEMBER COVER RH (for Model Code #J71 Series)
Remove the 2 screws and rear floor side member cover.
77377 17.REMOVE FUEL FILLER OPENING LID LOCK RETAINER
for Model Code #J71 Series:
Remove the bolt.
Detach the 3 claws and remove the retractor sub-assembly.
Remove the fuel lid lock control cable sub-assembly from the fuel filler opening lid lock retainer in the direction indicated by the arrow in the illustration.
77035 18.REMOVE FUEL LID LOCK CONTROL CABLE SUB-ASSEMBLY
Using a screwdriver, detach the cable from the clamps shown in the illustration.
Using a screwdriver, detach the cable from the clamps shown in the illustration.
| *A | for Model Code #J71 Series | *B | for Model Code #J76 Series |